Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preparation of a length of tube<br />
A)<br />
Cut a section from a K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> sheet corresponding to the circumference of the piping<br />
to insulate, with an abbundance of 5 cm, for the overlapping of the edges.<br />
A<br />
Circumference of the piping<br />
Length of the <strong>IC</strong> <strong>CLAD</strong> sheet section<br />
B)<br />
Remove a strip of 5 cm from the elastomeric layer<br />
where the abundance is, leaving the <strong>IC</strong> <strong>CLAD</strong> sheet intact.<br />
For the operation, make a clean cut in the elastomer and remove<br />
the remaining material with a scraper.<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
+5 cm<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - TUBE<br />
Use of the K-<strong>FLEX</strong> sheet with <strong>IC</strong> <strong>CLAD</strong> finishing already applied<br />
B<br />
+5 cm<br />
The illustration shows the operation for obtaining<br />
the necessary overlap for the superimposition of the joints.<br />
• As a makeshift solution, without doubt less effective, cut a sheet section without leaving an abbundance<br />
and simply cover the joints with <strong>IC</strong> <strong>CLAD</strong> adhesive, following the specific appliance rules.<br />
<strong>IC</strong> <strong>CLAD</strong> guida per l’applicazione 03/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - TUBES 11<br />
2
Change language