Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preparation of the internal covering K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> sections<br />
• Take the measurements of the<br />
elastomeric sheet and cut out the<br />
section of corresponding <strong>IC</strong> <strong>CLAD</strong><br />
sheet, leaving the correct abundance for<br />
the overlay (a).<br />
• Remove the elastomeric part from the<br />
areas of the abundance (also see pag. 3).<br />
• First place the external sheet<br />
sections* and then proceed gradualy<br />
towards the center of the roof ,<br />
overlaying every sheet to those layed<br />
before.<br />
In that way the slight difference in level<br />
of the overlapings will allow water to<br />
flow towards the outside ( ).<br />
<br />
• Glue the joints of the <strong>IC</strong> <strong>CLAD</strong><br />
sheet with K 420 adhesive and fix<br />
them with the specific <strong>IC</strong> <strong>CLAD</strong><br />
adhesive tape.<br />
*For the preparation of the external bands, see the following page.<br />
a<br />
a<br />
<br />
<br />
<br />
<br />
<br />
<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - LARGE TANKS<br />
Insulation and finishing with K-<strong>FLEX</strong> elastomeric sheet<br />
covered with <strong>IC</strong> <strong>CLAD</strong> sheet.<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - LARGE TANKS 18<br />
9
Change language