Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Preparation of the external K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> covering sections<br />
For the external K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> sections it is necessary to also protect the thickness<br />
of the curved side, turned towards the outside.<br />
In order to allow water to flow out the external edge, it is necessary to allow on the curved side<br />
another abundance (a) which includes the dimension of the K-<strong>FLEX</strong> sheet’s thickness<br />
plus 5/10 cm needed for an adequate overlapping to the sheet of the underlying wall (b).<br />
If necessary, make a cut in the overlap (c) to absorb the tension of the curvature.<br />
Glue the overlap with K 420 adhesive and fix the joints with the specific <strong>IC</strong> <strong>CLAD</strong> adhesive tape.<br />
a<br />
c<br />
c<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - LARGE TANKS<br />
Insulation and finishing with K-<strong>FLEX</strong> elastomeric sheet<br />
covered with <strong>IC</strong> <strong>CLAD</strong> sheet.<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
b<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - LARGE TANKS 17<br />
9
Change language