Application Manual K-FLEX IC-CLAD 1109.pdf

Finishing of the tank’s roof
K-FLEX IC CLAD - LARGE TANKS
Finishing with IC CLAD sheet
For the finishing to apply onto the roof, cover each K-FLEX elastomeric sheet, already previously placed,
with sections of IC CLAD sheet.
The example shown illustrates starting the covering from the circular area a) continuing gradually
with the internal areas proceeding towards the center, rispecting a criteria of overlapping
the joints in an orderly and functional manner to allow the water to flow from the center of the roof towards
the edges of the tank b).
• For the finishing of the tank’s roof
retrace the pattern of the elastomeric
sheets already in place.Take the
measurements of the elastomeric
sheet and cut the section of the
corresponding IC CLAD sheet ,
leaving the correct abundaces for the
overlapping (a).
•First place the outer sheet sections
and then gradually proceed towards
the center of the roof, overlapping
each sheet to those placed before.
In this way even the slight difference
in level of the overlappings will allow
the water to flow towards the outside
( ).
• Glue the joints with K 420 adhesive
and fix them with the specific IC
CLAD adhesive tape.
KEY: K 420 adhesive Marine silicone Measurements Actions
IC CLAD Application guide 04/04 - Engl.
IC CLAD - LARGE TANKS
9
08