Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
Application Manual K-FLEX IC-CLAD 1109.pdf
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
A)<br />
B)<br />
C)<br />
• Trace the outline in scale of the base of the tank with the correct<br />
subdivision in segments and the relevant quotas.<br />
Keep into consideration the central hole of the waste pipe.<br />
Leave on the outer edges an abundance sufficient to attach the segment<br />
to the wall of the tank a1).<br />
• Trace the section of a single segment with relevant abundance to allow<br />
overlapping of the joint (a2),<br />
• Cut out many segments of <strong>IC</strong> <strong>CLAD</strong> sheet, enough necessary to complete<br />
the covering of the base.<br />
• Apply the segments on the insulation glueing the parts and the overlappings<br />
of the sheet with K 420 adhesive (b1).<br />
• Apply the finishing also onto the joining ring around the waste pipe.<br />
A<br />
a2<br />
a1<br />
K-<strong>FLEX</strong> <strong>IC</strong> <strong>CLAD</strong> - SMALL AND MEDIUM TANKS<br />
Finishing with sections of <strong>IC</strong> <strong>CLAD</strong> sheet<br />
KEY: K 420 adhesive Marine silicone Measurements Actions<br />
B<br />
b1<br />
C<br />
<strong>IC</strong> <strong>CLAD</strong> <strong>Application</strong> guide 04/04 - Engl.<br />
<strong>IC</strong> <strong>CLAD</strong> - SMALL AND MEDIUM TANKS 06<br />
8