Application Manual K-FLEX IC-CLAD 1109.pdf

A)
B)
C)
• Trace the shape in the same scale of the tank’s curved base with
the appropriate subdivision in segments and the relevant quotas.
Keep in mind the central hole for the waste pipe.
• Trace the section of a single segment in full-size scale ,1:1 (a1).
Leave a sufficient abundance on the external edge (a2) to accomodate
the roundness of the base.
• Cut out mant segments of K-FLEX sheet, of a necessary quantity
to complete the covering of the base, and place them on the tank
glueing them with K 420 adhesive (b1).
• With the same adhesive glue the joints between one segment and
another.
• If necessary, cut out and apply a joining ring around the waste pipe,
with elastomeric material.
• Repeat the operation for the insulation of the cover, taking into
consideration the possible variations compared to the base.
The insulation of the
accessory parts on the tank
can be carried out before or
after the covering of the walls.
The installer will decide
based on his own experiance.
The accessory parts, usually of
a cyndrical shape, are insulated
with appropriate sections of
K-FLEX sheet cut to size and
applied with K 420 adhesive.
K-FLEX IC CLAD - SMALL AND MEDIUM TANKS
Insulation with sections of K-FLEX elastomeric sheet
A
KEY: K 420 adhesive Marine silicone Measurements Actions
a1
a2
B
b1
C
IC CLAD Application guide 04/04 - Engl.
IC CLAD - SMALL AND MEDIUM TANKS 04
8