Application Manual K-FLEX IC-CLAD 1109.pdf

E)
2
1
K-FLEX IC CLAD
Finishing of reducers facing downwards.
From three sections of IC / IN CLAD sheet cut out the three parts needed to complete the reducer (A1-2-3), leaving an abundance of 5 cm for
for the overlapping of the joining edges. Parts 1-2 need the indentation to cling to the respective upper part.
B) Finish off the first section of piping (B1) fixing the joining edges with K 420 adhesive.
C) Finish off the central section of the reducer (C2) fixing the joining edges with K 420 adhesive. Part 2 overlaps the indentation of part 1.
D) Finish off the upper section of the reducer (D2) fixing the joining edges with K 420 adhesive. Part 2 overlaps the indentation of part 1.
It is important to closely follow the
described installation sequence of
the parts to face the overlaps
against water.
• After fixing the parts, cover the
joints with the specific IC CLAD
adhesive tape.
For external applications, if
necessary, seal the edges of the
tapes with marine silicone.
A B C D E
3
KEY: K 420 adhesive Marine silicone Measurements Actions
1
2
3
IC CLAD Application guide 04/04 - Engl.
IC CLAD - REDUCERS 05
7