Application Manual K-FLEX IC-CLAD 1109.pdf

NO SI
K-FLEX IC CLAD
Practical suggestions
Some important tips for a correct installation of the K-FLEX IC CLAD finishings.
Application of the K-FLEX IC CLAD finishing layer
NO
Always use sharp blades to cut the insulating material cleanly and accurately, so as
to prevent any clippings or tearing of the finishing layer.
Always carry out overlapping against water to avoid infiltrations and stagnations;
for aesthetic purposes, face the overlappings out of sight.
For the application of the IC CLAD sheet, if it is not already self adhesive, use
K 420 ADHESIVE.
For fixing and finishings, only use the specific IC CLAD tapes.
For external applications, the edges of the fixings and the tapes must be sealed
with marine silicone.
Do not carry out the application of the IC CLAD finishing in the rain or apply the
specific insulation tape in wet environments or in the presence of humidity, which
may prevent a solid adhesion.
The green and
yellow lines
indicate:
Glued overlapping
part of the finishing
Edge sealed with
marine silicone
IC CLAD Application guide 04/04 - Engl.
IC CLAD - TOOLS 1
09