Total Access 1500 Single 4-Wire ETO Access Module ... - Adtran

Windows HyperTerminal
Windows HyperTerminal can be used as a VT100
terminal emulation program. Open HyperTerminal by
selecting Programs/Accessories/HyperTerminal. Refer
to the Help section of HyperTerminal for additional
information.
NOTE
To ensure proper display background, select
VT100 terminal emulation under SETTINGS.
Password and User Name
Password protection is a function of the SCU and is
factory disabled. If password authentication is enabled,
then the SCU will display the Logon screen. A valid
User Name and Password are required to access the
menus.
1. Configuration
2. Provisioning
3. Status
4. Test
Unit Name
CLEI Code
Part Number
Software Revision
FPGA Revision
1. Transmit TLP
2. Receive TLP
3. Tx Termination
4. Rx Termination
5. Sealing Current Mode
6. Equalizer Options
Transmit TLP
Receive TLP
Sealing Cur Mode
Sealing Cur State
EQ Height
EQ Bandwidth
EQ Slope
Cable Type
Digital Test
Metallic Test
1. 1004Hz Tone Test
2. Digital Network Loopback
Figure 3. 4W ETO Menu Tree
NOTE
The default User Name is “user”, and the
default Password is “password”. The User
Name and Password are not case sensitive.
Menu Navigation
To traverse through the menus, select the desired entry
and press ENTER. To work backward in the menu, press
the ESC key.
The menu tree in Figure 3 illustrates the path to every
provisioning, performance, and test access point in the
4W ETO menu.
Enter Value
1. 150
2. 600
3. 1200
1. None
2. Sink
3. Source
1. Off
2. To Network
3. To Loop
4. To Loop and Network
1. Inactive
2. Active
6 Issue 1, October 2003 61180113L2-5A
1. 150
2. 600
3. 1200
1. Height
2. Bandwidth
3. Slope
4. Cable Type
Enter Value
1. Loaded
2. Unloaded