FLIGHT TRAINING INSTRUCTION T-45 WEAPONS/STRIKE - Cnatra
FLIGHT TRAINING INSTRUCTION T-45 WEAPONS/STRIKE - Cnatra
FLIGHT TRAINING INSTRUCTION T-45 WEAPONS/STRIKE - Cnatra
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
T-<strong>45</strong> <strong>WEAPONS</strong>/<strong>STRIKE</strong> CHAPTER SEVEN<br />
will show the direction of the Offset Aimpoint and the wind speed determines the distance from<br />
the target. Worst case, go with the briefed OAP and adjust on subsequent runs.<br />
Approaching the target, Lead will call out the True Airspeed, Barometric Altitude, and wind<br />
readout from his HSI. At this time, verify Lead’s information roughly matches the indications in<br />
your cockpit. If you are more than 200’ or 20 knots off, call it out. A third aircraft should chime<br />
in and be the tie breaker. Otherwise, silence is consent and Lead will continue with the Breaking<br />
Maneuver.<br />
Passing over the target, everyone should take a moment and “clear” the target, ensuring there are<br />
no unwanted visitors in the target area. Everyone is a Range Safety Officer, Lead is ultimately<br />
responsible. If you see something that does not look right, say so.<br />
The Break into the Pattern<br />
Slightly before the target, Lead will call out “One breaking, High (Mid/Low) Pattern”. Dash<br />
Two maintains altitude and heading and breaks at an eight second interval for a four plane. The<br />
break interval for a three plane is ten seconds. When it’s your time to break, call out what Lead<br />
said on his break into the pattern. For example: “Two breaking, High (Mid/Low) Pattern.”<br />
Once the last aircraft in the flight has called “breaking”, Lead will make his position call with<br />
fuel state. When Two arrives at the abeam, Two will make his position call, “Two Abeam, 2.4”<br />
(for example). When Three arrives at the abeam, Three makes it’s position call, unless the flight<br />
is a three plane. The last aircraft in the flight will hold the position call until Lead calls “Off”,<br />
then the normal comm cadence begins. Pattern communications will be discussed in detail later<br />
on in this chapter.<br />
Figure 7-2 The Break into the Pattern<br />
TARGET AREA PROCEDURES 7-3