360 Modena gear box manual - All Ferraris

Adjustment
Before adjusting the length of the control cables, temporarily fit the gear selector.
Fasten the latter using the original screws and inserting four shims which must
feature the same thickness as the removed central console (about 3 mm).
1 Check that the control lever's is in the centre of the selector when in neutral
position.
2 Check that the gearshift is in neutral.
3 Check that the joints on the shifting lever housing side are almost completely
screwed down on their respective cable, leaving only some threads (about 2 mm)
above the check-nuts (6).
4 Adjust the position of the joints (8) on the gearbox side, so that the screw (1)
fastening them to the gearshift and selection lever inserts without being forced.
5 Tighten the joint check-nuts (6) and check the alignment once again.
6 Finally tighten the joint screws (1) onto their respective levers to the prescribed
torque.