360 Modena gear box manual - All Ferraris

5- Press "ENTER" to activate the tester.
6- Open the clutch draining union and wait 3÷4 seconds to let the oil flow out.
7- Close the draining union once again.
8- Top up the oil level in the tank.
9- Repeat procedures 6-7-8 two or three times, on both draining unions.
10- Once the operation has been completed, tighten the unions to the prescribed
torque.
11- Wait for the tester to exit the draining procedure and to display the related positive
result.
12- Shift gears a couple of times and top-up the level.
Gearbox actuator draining
To gain access to the draining screws, remove the actuator from the gearbox( D
6.07), keeping it connected to the hydraulic and electric system.
IMPORTANT
During this procedure, the actuator must be supported to prevent the sensor cables
from being taut and the pipes from being excessively bent(reduced radius of
curvature)
1- Connect the SD-2 tester to the diagnosis plug ( L 2.12).
2- Choose "DIAGNOSIS" from the main menu.
3- Check the level in the tank and top-up if necessary.
4- Loosen the three draining screws (3) by two turns.