360 Modena gear box manual - All Ferraris

This measurement is necessary to work out the thickness of the shim to be inserted
between the finger's terminal ball joint and the tool's resting surface, according to the
read diameter.
The table indicates the shim S) to be inserted according to the read diameter (D):
S (mm) D (mm)
0,25 14,75
0,20 14,80
0,15 14,85
If the diameter read is not within the reported values, identify the shim (S) to be used
in any case, following the logic reported in table (eg: with D= 14,90 use a shim S=
0,10, with D= 14,70 use S= 0,30).
• Connect the SD2 tester to the car's diagnosis socket ( L 2.12) and enter the
"360modena gearbox " application in the "Diagnosis" menu: select the "Actuator
centring" option.
• Position the AV3271 tool on the actuator, as illustrated in the figure, and insert the
feeler gauge blade(B), whose thickness was previously defined, between the lever's
terminal ball joint and the resting surface on the tool: Push the lever's end against the
tool.