360 Modena gear box manual - All Ferraris

NOTES
To facilitate gear-shifting, the gearbox oil must be at least at room temperature.
If the procedure has been completed successfully, a "beep" (acoustic signal) will be
heard.
If the procedure cannot be terminated due to interferences (these are signalled by 4
"beeps"), turn the key to the Stop position and wait for the display to switch off, then
repeat the procedure.
• Turn the key to the Stop position and wait for the display to switch off.
(*) Closed, new clutch value
TCU removal
To remove the TCU, it is necessary to:
• remove the ECU covering shield ( M 3.04);
• detach the two connections (A and B) (10P e 9P, see Table P - ELECTRICAL
SYSTEM) for the F1 gearbox cable from the TCU;
• remove the upper fastening bracket (1) from the TCU, by unscrewing the screws
(2);
• slide the TCU off of the lower bracket (3) and remove it from its support.