360 Modena gear box manual - All Ferraris

start-up the engine.
In the diagnosis program you will find the item “PIS setting”.
The PIS value taken from the Electronic Control Unit parameters will appear in the
initial mask.
This value can be increased/decreased by degrees of ± 0.1 mm.
The PIS variation range is the following:
- Min 4,0 mm
- Max 5,5 mm
When the value is confirmed by selecting “Save”, the PIS value displayed will be
stored in the Electronic Control Unit.
The basis for PIS value modification is as follows:
If, during vehicle testing, pickup proves to take place at a too high rpm (over
approximately 1700/1800 rpm), reduce the PIS value by 0.1mm by pressing the SD-2
menu key (–). There will be a 0.1mm variation each time the key is pressed.
We recommend to check the result of the PIS modification by testing the vehicle
each time a value is memorized.
If, on the other hand, pickup occurs at too low rpm or is too sharp, carry out the
same procedure in reverse order, increasing the PIS value using the SD-2 menu key
(+), and remembering to test the vehicle once again.
6 - IO setting:
Turn the key to the ON position, wait for the "check" of all the warning lights and
start-up the engine
Wait for the hydraulic oil to reach a temperature ranging from 38 and 83 ∞C. This
datum can be displayed by means of the SD-2 tester in the PARAMETERS,
environment.
Run the car engine idling for 5 minutes in neutral gear and 5 minutes with the 1 st
gear engaged while pressing the foot brake pedal.
Turn the key to the Stop position and wait for the display to turn off.
7 - Selection, engagement self-learning procedure (Polipo):
Release the parking brake lever, turn the key to the ON position and wait for the
warning lights "check".
Shift the gear to neutral.
Connect the SD-2 tester and activate the “ Self-learning” function in the
“Diagnosis” environment”
The system will engage all of the gears, progressively, from "R" to 6 th .