360 Modena gear box manual - All Ferraris

- pressure range: 0÷80 bar
- response tension: 0,5÷4,5 Volt
- supply: 5 Vcc.
To remove it, disconnect the F1 Gearbox connector from the harness and unscrew it
from the Power Unit.
Engine Revolution Speed Sensor
The engine rpm signal is generated by the engine ECU (square wave with duty cycle
50% and range 0 ÷ 12 Volts) and is sent to the TCU.
NOTES
The engine speed revolution signal is always acquired by the CAN line too.
Driver Side Door Opening Switch
The "open door on driver side" message reaches both the TCU and the alarm
system ECU, through an ON-OFF switch that closes the circuit to ground.
If this happens, with the car at a stop, the engine running, a gear engaged and foot
brake/accelerator pedals untouched, the system activates the buzzer and releases the
gear setting itself in neutral position.