360 Modena gear box manual - All Ferraris

• Remove the damaged casing and wash the joint.
• Put the new casing onto the central shaft and fasten it with the clamp (4).
• Lubricate the joint with MOLYKOTE BR2 grease and then mount the sleeve.
• Install the seeger ring (2) and fit the clamp (3).
• Mount the cover (1).
Re-assembly
• Carry out the re-assembly procedures as described in ( F 3.04), starting from
the insertion of the axle shaft into the bearing.
• Install the screws together with the shim plates and apply the prescribed grease on
the thread.
• Manually position the screws on the differential flange.
• Pre-tighten and finally tighten the screws to the prescribed torque.