360 Modena gear box manual - All Ferraris

NOTES
The thickness of the spacers supplied as spare parts may not correspond with the value
obtained using the above calculations: should this be the case, reduce the thickness of the
thickest supplied spacer using a surface grinder.
Re-assembly
• Using the tool AV 3260, fit the spacer (12) with the proper calculated thickness, along with
the outer race of the right-hand side bearing (8), in the gearbox housing's inner seat.
• Bring it flush using the press.
NOTES
Bearing in mind the possibility of having to disassemble the components in order to adjust the
pre-load values or to modify the impression between the crown wheel and pinion toothing, it is
advisable to use the fake ring AV 3274 with the same dimensions of the ball bearing (6), to avoid
damaging it during the removal procedure.