360 Modena gear box manual - All Ferraris

42 Lay shaft (pinion)
43 Flexible ring
44 Roller cage
45 Complete reverse gear (*)
46 Complete reverse synchroniser (*)
47 Retaining washer for reverse synchroniser rollers (*)
48 Flexible ring
49 Idle gear - Rev.
50 Idle gear shoulder ring
51 Roller casing
52 Driving pin
53 Complete oil pump
54 Lubrication nozzle
55 Union
56 Threaded taper plug
57 Threaded taper plug
58 Threaded taper plug (no. 3)
59 Oil bleeding
60 Driving dowels
61 O-ring for dowels
62 O-ring
63 Retaining bushing for bearing
64 Bushing screw
65 Flexible washer
(*) Starting FROM gearbox 10298 a new Reverse gear synchronizer with a 62 mm diameter is
installed (the diameter was previously 60 mm). This modification concerns not only the individual
components of the synchronizer, but also the Reverse gearing and the roller retaining washer. The
new parts cannot be used in combination with parts used before the modification. In the event that
even a single component among those mentioned is replaced, the complete Reverse synchronizer
and the new Reverse gearing must be fitted.