Lock-N-Load AP - Hornady

Step 7: Automatic Primer Feed Inspection
It is not necessary to install the primer tubes at this time to test your loader, but you must install the Primer
Body (14). Lower the Prmer Slide so that is stays in place. See step 4A for instructions on installing the Primer
Body (14).
At this point you should have installed a Shell Plate and the corresponding Primer Seater Punch (26) and
Primer Slide (15) for the cartridge for which you are loading.
Step 8: Installing the Lock-N-Load Powder Measure with Case Activated Powder Drop.
Figure 6: Lock-N-Load Powder Measure
UPPER ASSEMBLY
MEASURE ADAPTER
The Lock-N-Load Powder Measure combines with the Case Activated Powder Drop to mount on-top of the Lock-
N-Load A/P in station 2 or 3. The L-N-L Powder Measure that was shipped with the press has been factory fitted
with the case activiated Powder Drop.
* This press comes packaged with the Standard Rotor & Standard Metering Insert and the Pistol Rotor & Pistol Metering Insert.
Refer to the Lock-N-Load Powder Measure and Case Activated Powder Drop instructions for cleaning and
functionality. (These instructions are included).
- 13 -
STATION 1
STATION 2