S1800 Marine Model Ice Machines – Service Manual - Manitowoc Ice
S1800 Marine Model Ice Machines – Service Manual - Manitowoc Ice
S1800 Marine Model Ice Machines – Service Manual - Manitowoc Ice
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 4 Maintenance<br />
Water Inlet Valve<br />
The water inlet valve normally does not require removal<br />
for cleaning. Refer to Section 5 for a list of causes for<br />
“No Water Entering Water Trough” or “Water Overflows<br />
Water Trough.<br />
1. When the ice machine is off, the water inlet valve<br />
must completely stop water flow into the machine.<br />
2. When the ice machine is on, the water inlet valve<br />
must allow the proper water flow through it. Set the<br />
toggle switch to ON. Watch for water flow into the ice<br />
machine. If the water flow is slow or only trickles into<br />
the ice machine, refer to Section 5.<br />
Follow the procedure below to remove the water inlet<br />
valve.<br />
! Warning<br />
Disconnect the electric power to the ice machine<br />
and dispenser at the electric service switch box and<br />
turn off the water supply before proceeding.<br />
1. Remove the 1/4” hex head screws.<br />
2. Remove, clean, and install the filter screen.<br />
FILTER<br />
ACCESS<br />
SCREWS<br />
WATER<br />
INLET<br />
VALVE<br />
SV1622<br />
Part Number 80-1634-3 4-11