Sehr geehrte Mitarbeiterin, Sehr geehrter Mitarbeiter - OEG AG
Sehr geehrte Mitarbeiterin, Sehr geehrter Mitarbeiter - OEG AG
Sehr geehrte Mitarbeiterin, Sehr geehrter Mitarbeiter - OEG AG
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Manual<br />
Digistrob RDS 30<br />
8 Maintenance, service lifetime, changing the flash tube<br />
The flash-light stroboscope DIGISTROB RDS 30 requires no maintenance.<br />
However it should be protected against moisture. The RDS 30 must not be opened and it<br />
must not be subjected to strong vibration or shock.<br />
Under full load the Xenon white light flash tube has a minimum service lifetime of approx. 250<br />
hours. Also the hand lamp should not be subjected to strong vibration or shock.<br />
For changing a flash tube proceed as follows:<br />
1. Switch off the apparatus!<br />
2. Disconnect the hand lamp!<br />
3. Hold the lamp shade A from the front<br />
and turn with force anti-clockwise, till it<br />
stops (bayonet fitting). Now the lamp<br />
shade can be removed.<br />
4. Remove cover B by inserting a<br />
screwdriver in the small aperture at the<br />
side and twisting it.<br />
5. Loosen the two screws D and E and take<br />
away the side plate C.<br />
6. Now the black cooler body which<br />
encases the flash lamp, can be slid off<br />
forward.<br />
7. The flash tube is now open and can be detached.<br />
Hold the new flash tube only at the plug: When<br />
inserting it, make sure that the catch of the plug<br />
correctly snaps home.<br />
8. The hand lamp is now reassembled in reverse<br />
order. Make sure that the black cooler body is<br />
fastened tightly in its guide. Turn the cover B so,<br />
that the small notch fits into the groove and snaps home.<br />
Also turn the lamp shade A so, that the two notches fit into the the guide.<br />
Then turn the groove towards the upper center slot (clockwise), until the lamp shade<br />
snaps home.<br />
The hand lamp is now again ready for use.<br />
ATTENTION: NEVER APPLY FORCE WHEN DISMANTLING!<br />
Page 12/20, Manual