Sehr geehrte Mitarbeiterin, Sehr geehrter Mitarbeiter - OEG AG
Sehr geehrte Mitarbeiterin, Sehr geehrter Mitarbeiter - OEG AG
Sehr geehrte Mitarbeiterin, Sehr geehrter Mitarbeiter - OEG AG
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Manual<br />
Digistrob RDS 30<br />
7 Taking into operation<br />
Before the Digistrob RDS 30 is connected to the mains, we recommend the following<br />
procedure:<br />
• Connect hand lamp<br />
• Check that the correct range has been set at the control elements at the front and that<br />
not several keys have been depressed simultaneously.<br />
Recommended adjustment: display rpm 2 or Hz 3 internal triggering 14.<br />
• At the mode selector (24) at the back, place all switches in the upward position in<br />
order to avoid having activated any unwanted special functions<br />
• Make sure that the mains connection is in accordance with the data given on the<br />
apparatus (230V / 50 - 60Hz)<br />
Now the apparatus can be connected to the power outlet and can be switched on with the<br />
power switch 1. In this setting the display 6 will light up after a short interval. Now the<br />
frequency can be changed with the double control knob 16 and the display and function of<br />
the apparatus can be tested. By switching on the hand lamp switch 17 also the function of the<br />
hand lamp can be tested. The flash light stroboscope Digistrob RDS 30 is now ready for<br />
operation. The required working range and the special functions can now be adjusted for the<br />
required application.<br />
ATTENTION!<br />
NEVER DISCONNECT THE HAND LAMP DURING OPERATION.<br />
This could cause damage to the electronics!<br />
Page 11/20, Manual