Programm Photovoltaik Ausgabe 2009 ... - Bundesamt für Energie BFE
Programm Photovoltaik Ausgabe 2009 ... - Bundesamt für Energie BFE Programm Photovoltaik Ausgabe 2009 ... - Bundesamt für Energie BFE
7/10 From the UV-VIS data, it is clearly visible that the dye Yellow83 absorbing in the 400 to 500 nm range is degraded first during the 824 hours in the 470 nm LED light, then the degradation goes on with the SolarTest-65 simulated solar light having an intensity of ca. 950 W/m 2 . The absorption of the dye Red305 in the 500 to 600 nm domain is only reduced by a small amount after the 2 irradiation test periods. Graph 7: UV-VIS spectra of sample ECN779 after 824 hours exposure to the 470 nm LED light, followed by 1300 hours irradiation in SolarTest-65 lamp with A-bulb: Similarly to the ECN778 sample, this sample containg the dye Yellow170 sees most degradiation with the Yellow170 component, while the Red305 peak around 575 nm is only reduced in absorption by a rather small amount, after the irradiation tests. Graph 8: UV-VIS spectra of sample ECN780 after 824 hours exposure to the 470 nm LED light, followed by 1300 hours irradiation in SolarTest-65 lamp with A-bulb: Again, in this ECN780 sample, the CRS040 dye absorbing in the 370 to 480 nm range sees most degradation with near complete disappearance of the absorption peak at 440 nm, while the Red305 peak around 575 nm is only reduced in absorption by a rather small amount, after 82 hours 470 nm LED light followed by 1300 hours simulated solar light. Short-circuit photocurrent monitored over time of the 3 samples exposed in simulated solar light irradiation in the SolarTest-65 lamp with the A-bulb, corresponding to ca. 950 W/m 2 light intensity. FULLSPECTRUM, T. Meyer, Solaronix 159/290 Graph 9: Short-circuit current of the FPC side attached Si-cell monitored over time, during SolarTest-65 lamp (A-bulb) irradiation.
The table below shows the change of photocurrent for these 3 samples subject to 1300 hours of simulated solar light irradiation in SolarTest-65 lamp with A-bulb, after having seen the 470 nm light for 824 hours in an earlier stability test: FPC samples measured in Xe-lamp set to 1000 W/m 2 Sample Current at start (mA) Current after 1300 hr SolarTest-65 (mA) Change in current (%) FPC ECN 778 7.95 7.57 - 7 % FPC ECN 779 12.7 14.02 + 11.5 % FPC ECN 780 9.01 8.05 - 10 % Table 3: Short-circuit photocurrent change over time during the 1300 hour long SolarTest-65 simulated sunlight irradiation. FPC samples measured in CDM-1000 lamp set to 1000 W/m 2 Sample Current at start (mA) Current after 1300 hr SolarTest-65 (mA) Change in current (%) FPC ECN 778 11.1 11.16 - 5.4 % FPC ECN 779 18.36 18.8 + 2.4 % FPC ECN 780 11.8 11.36 - 3.7 % Table 4: Short-circuit photocurrent change over time during the 1300 hour long SolarTest-65 simulated sunlight irradiation. The short-circuit currents of the crystalline Si-cells attached on the FPC side show only a minor change after the 1300 hours in the SolarTest-65 simulated solar irradiation set to an intensity of ca. 950 W/m 2 , when measured in a Xe-lamp and the CDM-1000 metal halide lamp. A continous irradation of 1300 hours in simulated solar light corresponds about to 1.3 years of outdoors light exposure in central Europe. The 3 samples ECN778, ECN 779 and ECN 780 have seen in total 824 hours 470 nmLED light corrsponding to the 470 nm light exposure over one year, and 1300 hours of SolarTest-65 lamp with the A-bulb, again adding about 1.3 years of outside equivalent light dose. The dyes Yellow83, Yellow170 and CRS040 are not suited in the current flat plate concentrator application, as these degrade manifestly when exposed to high light doses. 2) Accelerated light soaking tests with quantum dot flat plate concentrators (QD-FPC) provided by the University of Utrecht and the FHG-IAP Golm. Quantum dot containing FPC (QD-FPC) composition: FULLSPECTRUM, T. Meyer, Solaronix 160/290 Table 5: QD-FPC sample compositions investigated during simulated sunlight test in the SolarTest lamp. 8/10
- Page 112 and 113: 5/9 Indium sulfide layer characteri
- Page 114 and 115: 7/9 3) Semitransparent CIGS solar c
- Page 116: 9/9 Steps towards multi-junction so
- Page 119 and 120: Introduction / project objectives T
- Page 121 and 122: Figure 2: SEM picture of laser-abla
- Page 123 and 124: Introduction / project objectives T
- Page 125 and 126: Work progress and achievements duri
- Page 127 and 128: Furthermore, with a good reproducib
- Page 129 and 130: Main achievements - The association
- Page 131 and 132: Introduction Dye-sensitized solar c
- Page 134 and 135: Eidgenössisches Departement für U
- Page 136 and 137: 3/4 So far, experiments were perfor
- Page 138 and 139: Eidgenössisches Departement für U
- Page 140 and 141: 3/5 Tasks of the collaboration part
- Page 142: 5/5 Figure 4: Maximum achievable sh
- Page 145 and 146: Project Goals The goal is the estab
- Page 147 and 148: Evaluation 2008 and Outlook 2009 L'
- Page 149 and 150: Project Goals NAPOLYDE industrials
- Page 151 and 152: � Organic large solar panel and
- Page 153 and 154: Materials such as the conductive ca
- Page 155 and 156: National and international collabor
- Page 157 and 158: Project Goals The aim of FULLSPECTR
- Page 159 and 160: In addition, every two years, the P
- Page 161: The table below show the change of
- Page 165 and 166: 4. The UV-A tests with PMMA films c
- Page 167 and 168: Introduction / Project Goals The co
- Page 169 and 170: Fig. 4. Schematic illustration of a
- Page 172 and 173: THINPV Eidgenössisches Departement
- Page 174 and 175: 3/6 IR laser source Pumping line IR
- Page 176 and 177: 5/6 Figure 2: Scheme of a monolithi
- Page 178 and 179: PECNET Eidgenössisches Departement
- Page 180 and 181: 3/10 Projektziele Dieses Forschungs
- Page 182 and 183: 5/10 und mit Stichworten katalogisi
- Page 184 and 185: 7/10 einer Vorverpflichtung mit rel
- Page 186 and 187: 9/10 NanoPEC Partner IEA HIA Annex
- Page 188: Module und Gebäudeintegration T. S
- Page 191 and 192: Einleitung / Projektziele Obwohl be
- Page 194 and 195: ULTRALIGHT PHOTOVOLTAIC STRUCTURES
- Page 196 and 197: 3/8 Task 2. Encapsulation of Si-bas
- Page 198 and 199: 5/8 Figure 9: polyester/glass fiber
- Page 200 and 201: 7/8 Figure 16: Flexible DSCmodule F
- Page 202: Systemtechnik D. Chianese, N. Cereg
- Page 205 and 206: Aim of the project The aim of the
- Page 207 and 208: The short circuit current of each P
- Page 209 and 210: TEST cycle 11 In 2008 a new 15 mont
- Page 211 and 212: Evaluation 2008 and prospects for 2
The table below shows the change of photocurrent for these 3 samples subject to 1300 hours of<br />
simulated solar light irradiation in SolarTest-65 lamp with A-bulb, after having seen the 470 nm light for<br />
824 hours in an earlier stability test:<br />
FPC samples measured in Xe-lamp set to 1000 W/m 2<br />
Sample Current at start (mA) Current after 1300 hr SolarTest-65 (mA) Change in current (%)<br />
FPC ECN 778 7.95 7.57 - 7 %<br />
FPC ECN 779 12.7 14.02 + 11.5 %<br />
FPC ECN 780 9.01 8.05 - 10 %<br />
Table 3: Short-circuit photocurrent change over time during the 1300 hour long SolarTest-65 simulated<br />
sunlight irradiation.<br />
FPC samples measured in CDM-1000 lamp set to 1000 W/m 2<br />
Sample Current at start (mA) Current after 1300 hr SolarTest-65 (mA) Change in current (%)<br />
FPC ECN 778 11.1 11.16 - 5.4 %<br />
FPC ECN 779 18.36 18.8 + 2.4 %<br />
FPC ECN 780 11.8 11.36 - 3.7 %<br />
Table 4: Short-circuit photocurrent change over time during the 1300 hour long SolarTest-65 simulated<br />
sunlight irradiation.<br />
The short-circuit currents of the crystalline Si-cells attached on the FPC side show only a minor<br />
change after the 1300 hours in the SolarTest-65 simulated solar irradiation set to an intensity of ca.<br />
950 W/m 2 , when measured in a Xe-lamp and the CDM-1000 metal halide lamp.<br />
A continous irradation of 1300 hours in simulated solar light corresponds about to 1.3 years of<br />
outdoors light exposure in central Europe.<br />
The 3 samples ECN778, ECN 779 and ECN 780 have seen in total 824 hours 470 nmLED light<br />
corrsponding to the 470 nm light exposure over one year, and 1300 hours of SolarTest-65 lamp with<br />
the A-bulb, again adding about 1.3 years of outside equivalent light dose.<br />
The dyes Yellow83, Yellow170 and CRS040 are not suited in the current flat plate concentrator<br />
application, as these degrade manifestly when exposed to high light doses.<br />
2) Accelerated light soaking tests with quantum dot flat plate concentrators (QD-FPC)<br />
provided by the University of Utrecht and the FHG-IAP Golm.<br />
Quantum dot containing FPC (QD-FPC) composition:<br />
FULLSPECTRUM, T. Meyer, Solaronix<br />
160/290<br />
Table 5: QD-FPC sample compositions<br />
investigated during simulated sunlight test<br />
in the SolarTest lamp.<br />
8/10