EQUATOR® Convective Warmer - Smiths Medical
EQUATOR® Convective Warmer - Smiths Medical
EQUATOR® Convective Warmer - Smiths Medical
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
S E C T I O N 1 2 • S p e c i f i c a t i o n s<br />
Mode of Operation Continuous<br />
Type of Current Alternating<br />
Ingress Protection Rating<br />
Performance<br />
IPX1<br />
Relative Average Noise Level at 1000 Hz<br />
(front and back)<br />
40 dBA - 45 dBA<br />
Hose End Temperature Control Servo-controlled by thermistors placed at hose end<br />
The Snuggle Warm ® Electrical Type<br />
convective warming Average Maximum<br />
blankets meet the average and maximum<br />
contact surface temperature specified in<br />
ASTM F2196.02<br />
46°C 48°C<br />
Approximate time to change the average<br />
contact surface temperature from 20°C to<br />
36°C<br />
7 minutes<br />
Electromagnetic Environmental Recommendations<br />
Recommended separation distances between portable and mobile RF communications<br />
equipment and the EQUATOR ® <strong>Convective</strong> <strong>Warmer</strong><br />
The convective warmer is intended for use in an electromagnetic environment in which radiated RF<br />
disturbances are controlled. The customer or the user of the convective warmer can help prevent<br />
electromagnetic interference by maintaining a minimum distance between portable and mobile RF<br />
communications equipment (transmitters) and the convective warmer as recommended below, according to<br />
the maximum output power of the communications equipment.<br />
Rated maximum Separation distance according to frequency of transmitter m<br />
output power of 150 kHz to 80 MHz 80 MHz to 800 MHz 800 MHz to 2.5 GHz<br />
transmitter<br />
d=[3.5/V1]P<br />
d=[3.5/E1]P<br />
d=[7/E1]P<br />
W<br />
0.01 0.116 0.116 0.233<br />
0.1 0.368 0.368 0.737<br />
1 1.16 1.16 2.33<br />
10 3.69 3.69 7.38<br />
100 11.66 11.66 23.33<br />
For transmitters rated at a maximum output power not listed above, the recommended separation distance<br />
d in metres (m) can be estimated using the equation applicable to the frequency of the transmitter, where P<br />
is the maximum output power rating of the transmitter in watts (W) according to the transmitter<br />
manufacturer.<br />
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.<br />
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by<br />
absorption and reflection from structures, objects and people.<br />
34 EQUATOR ® <strong>Convective</strong> <strong>Warmer</strong> | Operator’s Manual