Operator's Manual - Smiths Medical

More documents

Recommendations

Info

S E C T I O N 5 • O p e r a t i o n SECTION 5 Operation Operation of the EQUATOR ® Convective Warmer is monitored and controlled by the control panel. This section describes the control panel and the modes of operation. Control Panel The Control Panel provides the following controls, indicators, and displays used during operation of the convective warmer. 1 Power ON/OFF Buttons 2 Temperature Setting Buttons 3 Operation Indicators 4 Temperature Display On some convective warmers the control panel may contain the Elapsed Time Display (5). This function displays in hours (h = hours) the cumulative time use of the convective warmer. 12 EQUATOR ® Convective Warmer | Operator’s <strong>Manual</strong>
Controls, Indicators, and Displays S E C T I O N 5 • O p e r a t i o n The following table defines each control, indicator, and display and the modes of operation. Control/Indicator Definition Power ON Button The green button powers ON the convective warmer. Power OFF Button The orange button powers OFF operating components of the convective warmer. Note: To remove all power from the convective warmer, the MAINS power cord must be removed from the electrical receptacle. Ambient Air Temperature Setting Button When selected, the heater is turned off and the motor still operates (air flows). 36°C Temperature Setting Button When selected, the air temperature is set to 36°C at the hose end. 40°C Temperature Setting Button When selected, the air temperature is set to 40°C at the hose end. 44°C Temperature Setting Button When selected, the air temperature is set to 44°C at the hose end. Over Temperature Alarm Indicator If the hose end temperature is more than 3°C (± 1°C) above the selected temperature, the indicator illuminates, a continuous audible alarm sounds, and the heater and motor shut off. Under Temperature Indicator If the hose end temperature is more than 3°C (± 1°C) below the selected temperature, this indicator flashes. Disconnect Indicator If the thermistor cable or the hose is not attached properly, this indicator illuminates, an audible alarm sounds and repeats approximately every five seconds, and the heater and motor shut off. If the heater has an open wire circuit, this indicator illuminates, an audible alarm sounds and repeats approximately every five seconds, the heater shuts off, but the motor continues to operate (air flows). Hose End Temperature Display Displays the temperature of the air at the hose end. EQUATOR ® Convective Warmer | Operator’s <strong>Manual</strong> 13
Page 1 and 2: EQUATOR ® Convective Warmer < EQ-5
Page 3 and 4: Contents 1. About this Manual 1 Ind
Page 5 and 6: SECTION 1 About this Manual S E C T
Page 7 and 8: Rear View 1 Thermistor Receptacle -
Page 9 and 10: SECTION 3 Important Safety Informat
Page 11 and 12: S E C T I O N 3 • I m p o r t a n
Page 13 and 14: SECTION 4 Assembly Instructions S E
Page 15: S E C T I O N 4 • A s s e m b l y
Page 19 and 20: Step 2: Determine the Convective Wa
Page 21 and 22: Attaching the Older Style Sheet Cli
Page 23 and 24: 3 Verify that the self-test complet
Page 25 and 26: Problem Possible Cause/Solution Und
Page 27 and 28: 7 After thoroughly cleaning the con
Page 29 and 30: S E C T I O N 8 • M a i n t e n a
Page 31 and 32: S E C T I O N 8 • M a i n t e n a
Page 33 and 34: SECTION 10 Limited Warranty S E C T
Page 35 and 36: SECTION 11 Service S E C T I O N 1
Page 37 and 38: SECTION 12 Specifications System Sp
Page 39 and 40: SECTION 13 Symbols Symbols Definiti
Page 41 and 42: Symbols Definitions 6 CLASS 1 ; : C
Page 43 and 44: Convective Warming Blanket A P P E
Page 45 and 46: Convective Warming Blanket A P P E
Page 47 and 48: APPENDIX B A P P E N D I X B • P
Page 49 and 50: A P P E N D I X B • P o s i t i o
Page 67 and 68:
I n d e x Numerics 36°C Temperatur
Page 69:
I n d e x Thermistor receptacle 3 T
show all

Operator's Manual - Smiths Medical

Create successful ePaper yourself

Delete template?

Save as template?