6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>6700</strong> SAMPLERS<br />
RUNNING PROGRAMS<br />
To run a standard or extended program, select RUN from the<br />
main menu. You may also select YES at the RUN THIS PRO-<br />
GRAM NOW? screen at the end of the programming screens.<br />
This is illustrated in Figure 11.<br />
Extended programs scheduled to start at a clock time will not<br />
start until the programmed clock time on or after the first valid<br />
date.<br />
Note that if you have recently calibrated a parameter probe, the<br />
sampler may delay the start and display “PLEASE WAIT” until<br />
valid readings are expected from the probe. The delay accounts<br />
for the time typically required to install the probe, and lasts for<br />
five minutes after you complete the calibration.<br />
RUN TIME SCREENS<br />
While running a sampling program, the sampler displays a variety<br />
of messages that report the program’s status. For example, if<br />
the sampler has not yet reached the programmed start time, it<br />
displays the scheduled start time as well as the current time. (A<br />
few common run time displays are illustrated in Figure 11.)<br />
Once the program reaches the start time, you can determine the<br />
time of the next sample, the next bottle to receive a sample, sample<br />
distribution, and other information. Other messages appear<br />
while the sampler runs through a sampling cycle as it takes a<br />
sample. When the sampler needs to report multiple messages, it<br />
alternates them, displaying each for one to three seconds.<br />
Module and YSI Sonde Readings<br />
<strong>Sampler</strong>s with an attached module display the module’s readings:<br />
pH and temperature for the pH module; percentage or flow<br />
rate for the 4-20 mA module; level, flow-rate, and flow volume<br />
readings for the flow modules; level, velocity, flow-rate, and positive<br />
flow volume readings for the area velocity module. Some<br />
module screens will alternate with the sampler screens.<br />
<strong>Sampler</strong>s with an attached YSI Sonde will display the parameter<br />
readings selected during the YSI hardware setup. The YSI screens<br />
alternate with the sampler and module screens.<br />
52<br />
BOTTLE 2<br />
IN 00:14:39<br />
150 gpm 0.82 ft<br />
00001438200 gal<br />
Y-pH: 8.1<br />
Y-D.O: 4.90 mg/l<br />
Y-TDS: 1.000 g/l<br />
Y-TEMP: 29.2 C