6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Flow Meter<br />
Connector<br />
Rain Gauge<br />
Connector<br />
YSI 600 Sonde<br />
<strong>6700</strong> SAMPLERS<br />
CONNECTING EXTERNAL INSTRUMENTS<br />
Flow Meter Connector<br />
Connect the sampler to <strong>Isco</strong> flow meters, flow loggers, PAL 1101s,<br />
or 1640 Liquid Level Actuators by attaching their connect cable<br />
to the Flow Meter Connector. When using the sampler with an<br />
external instrument, remember these guidelines:<br />
Both the sampler and the flow instrument must be on and<br />
running a program.<br />
Ifusingaflowmeterorflowloggerforflowpacing,thesampler<br />
and the flow instrument must both run programs with<br />
flow pacing settings.<br />
Ifusingaflowmeterorflowloggerfortriggerpacing,thesampler<br />
must run a program with flow pacing settings, and the flow<br />
instrument must run a program with trigger pacing settings.<br />
When the sampler runs an event-paced program, it disregards<br />
pacing pulses from a flow meter or flow logger. However,<br />
the sampler continues to monitor for enable signals.<br />
(See <strong>Sampler</strong> Enable on page 87.)<br />
Rain Gauge Connector<br />
Connect the rain gauge, YSI Sonde, or Refrigerator Temperature<br />
Sensor connect cables to the nine-pin Rain Gauge Connector.<br />
(<strong>Sampler</strong>s with a four-pin Rain Gauge Connector can only accept<br />
a rain gauge.) When connecting a rain gauge and a YSI Sonde, or<br />
rain gauge and a Refrigerator Temperature Sensor, use the<br />
appropriate Y-connect cable. See the Accessories appendix at the<br />
end of this manual.<br />
Notes<br />
Select Extended Programming to use the YSI sonde. (See<br />
Changing to and from Extended and Standard Screens on<br />
page 25.)<br />
Update the Hardware Setup whenever you add or remove a<br />
rain gauge, refrigerator temperature sensor, or YSI sonde.<br />
(See Hardware Setup on page 93.)<br />
In extended programming, rain gauge and YSI sonde readings<br />
are only available if they are selected in the Hardware Setup.<br />
However, when using standard programming, rain gauge readings<br />
are automatically stored in the sampler’s memory.<br />
LOCKING THE SAMPLER<br />
<strong>Isco</strong> offers stainless steel cables to lock the sampler (standard<br />
size – use P/N 68-<strong>6700</strong>-134; compact – use 68-<strong>6700</strong>-111). To lock<br />
the sampler, place the hook through the center section latch.<br />
Repeat this for the other two latches, and then pull the ends of<br />
the cables together over the top of the sampler. Lock the loops<br />
with the padlock. You can also lock each latch individually, using<br />
three padlocks, one for each of the latches.<br />
50