6700 Portable Sampler User Manual - Isco

6700 SAMPLERS
Figure 3 Placing the 24-bottle kit in a standard tub
1. Install the bottles then secure
the plastic retaining ring with
the three draw cords. (For
glass bottles use the stainless
steel retaining ring).
2. Adjust the distributor arm to
the correct position, insert the
discharge tube, and attach the
distributor arm.
INSTALLING BOTTLE KITS
The samplers are shipped from the factory with sample bottles in
place. When using the sampler for the first time, you will only
need to remove the bottle lids. When installing cleaned bottles or
a new kit, keep these guidelines in mind:
Do not mix glass and plastic bottles together.
Install all bottles to insure that they remain in place.
Align the bottles correctly. If the bottles are misaligned, the
sampler may miss the bottle mouth, or the sampler will
deposit samples in the “wrong” bottle.
Each time you change from one size bottle to another, you
must adjust the length of the distributor arm and install a discharge
tube of the correct length.
Each time you install a bottle kit, check the program settings
for the number of bottles and bottle volume.
You must adjust the distributor arm and use a different discharge
tube for each bottle kit. See Installing Distributor Arm and Table 6
for more information.
Aligning Bottle Kits in the Standard Tub
Figures 3 through 6 show each kit being installed in the standard
tub. Refer to Table 6 to adjust the distributor arm to the
correct length and use the correct length of discharge tube.
41