6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Distributor Arm<br />
Figure 2 Installing the Distributor Arm<br />
Step 1<br />
The two-piece arm has four positions,<br />
marked on the underside<br />
with the letters A, B, C, andD.<br />
Adjust the arm to the correct position<br />
for the bottle kit. Table 6<br />
shows you the correct position for<br />
each kit.<br />
Thread the discharge through the<br />
spring and arm so that the tube<br />
protrudes from the arm 1/16 to 1/8<br />
inch.<br />
Step 2<br />
Attach the arm to the distributor<br />
shaft. The arm and shaft are<br />
keyed so that you can align them<br />
correctly. Secure the arm to the<br />
shaft with the black plastic nut.<br />
Step 3<br />
Slide the end of the discharge<br />
tube onto the bulkhead fitting.<br />
<strong>6700</strong> SAMPLERS<br />
PREPARING THE SAMPLER<br />
INSTALLING THE DISTRIBUTOR ARM<br />
AND DISCHARGE TUBE<br />
When sampling with multiple bottles, both the compact and standard<br />
<strong>6700</strong> <strong>Sampler</strong>s use a distributor arm. It is adjustable so that<br />
you can position the discharge tube over the bottles of each kit.<br />
Each bottle kit also uses a discharge tube of a specific length.<br />
Table 6 liststhecorrectdischargetubelengthsforeachbottlekit.<br />
After installing the distributor arm and discharge tube, run the<br />
distributor to each bottle position to ensure proper installation.<br />
If using bulk tubing to cut your own tubes, cut the ends of the<br />
tube square, not at an angle, and cut the length accurately.<br />
The two-piece distributor arm has four positions, marked on the<br />
undersidewiththelettersA,B,C,andD.Adjustthearmtothe<br />
correct position for the bottle kit being used. Table 6 shows the<br />
correct position for each kit. Thread the discharge tube through<br />
the spring and arm so that the tube protrudes from the arm 1 /16<br />
to 1 /8 inch.<br />
Attach the arm to the distributor shaft. Secure the arm with the<br />
black plastic nut. Slide the free end of the discharge tube onto<br />
the bulkhead fitting.<br />
39