6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
6700 Portable Sampler User Manual - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Figure 24 Password Protected Functions<br />
From Standby<br />
RUN<br />
PROGRAM<br />
VIEW REPORT<br />
OTHER FUNCTIONS<br />
While Running a Program<br />
<strong>6700</strong> SAMPLERS<br />
ENTER PASSWORD:<br />
____<br />
VIEW DATA<br />
PRINT DATA<br />
SYSTEM IDs<br />
CONFIGURE REPORTS<br />
ENTER PASSWORD:<br />
____<br />
SAMPLE 3<br />
Stop Key<br />
IN 00:03:26 ENTER PASSWORD:<br />
____<br />
On/Off Key<br />
Note<br />
The interrogator cable must be<br />
disconnected before you can<br />
use the modem.<br />
ENTER PASSWORD:<br />
____<br />
SWITCH BOTTLE SET AT ENABLE<br />
When this software option is activated, it allows the <strong>6700</strong> to<br />
switch to a new bottle set each time a program part becomes<br />
enabled. The sample interval will be reset at the enable time,<br />
and a sample will be taken if programmed to SAMPLE AT<br />
ENABLE.<br />
TELEPHONE COMMANDS<br />
Several commands are available to control the sampler’s<br />
operation from a remote location. Telephone commands require<br />
the sampler to be equipped with the factory-installed 2400 baud<br />
talking modem.<br />
After connecting to the sampler from a touch-tone telephone,<br />
command numbers may be entered from the telephone’s keypad,<br />
followed by the # (pound) button. The commands are listed in<br />
Table 13.<br />
To use telephone commands:<br />
1. Dial the sampler’s telephone number. When the sampler connects,<br />
it answers with “<strong>Isco</strong> <strong>Sampler</strong> Site [number].” If the sampler<br />
does not receive a command in five seconds, it assumes that<br />
a computer modem has called and initiates the modem connect<br />
sequence. If this occurs you must hang up and try again.<br />
2. Enter the command. For example, to run program 1, press 1<br />
#<br />
.<br />
3. If the command is valid for its current state of operation, the<br />
sampler responds with “[command number], please acknowledge.”<br />
If the command is not valid the sampler responds with<br />
the command number followed by three quick beeps. Enter a<br />
valid command.<br />
108<br />
Programming<br />
Screens<br />
ENTER PASSWORD:<br />
____<br />
MAINTENANCE<br />
MANUAL FUNCTIONS<br />
PROGRAMMING STYLE<br />
STOP PROGRAM<br />
RESUME PROGRAM<br />
VIEW DATA<br />
GRAB SAMPLE<br />
SAMPLINK REPORT<br />
FLOWLINK REPORT<br />
CUSTOM REPORT<br />
ALL REPORTS