6700 Portable Sampler User Manual - Isco

Note
When updating the Flash
memory, power must be
applied to the sampler.
6700 SAMPLERS
If you need to collect sampling results and partition data, do this
before allowing the sampler to create and size the partitions. The
stored data is lost as the sampler reformats its memory. As a
precaution, the sampler displays the screen below.
When YES is selected, the sampler clears the stored data and
reformats the memory partitions. The sampler then displays the
new capacity of the partition memory.
If the duration is too short, try changing the data storage interval
or eliminating unnecessary reading types in the Hardware or
Module Setup. For example, a sampler configured with a 730 Bubbler
Module and a rain gauge storing data at a one-minute interval,
creates level and rainfall partitions that hold 13 days of
readings. Changing the storage interval to two minutes extends
the storage capacity to 26 days.
The sampler does not have to be running a program to store
readings. When the sampler is on, it stores readings at the
selected data storage interval. Once the partition is filled, the
readings roll over.
When the sampler is running a program, the partitions become
“triggered” by the programmed start time or the first enable
time, whichever is later. A triggered partition continues to log
readings at the selected interval, but will not replace any readings
taken after the trigger event. The sampler fills the partition
and then stops recording to preserve the data. The first reading
preserved in a full partition is one hour before the trigger event.
A full partition can be reset by starting another program or
changing storage parameters.
If you require continuous readings for analysis, be sure to collect
the readings before the partition fills or rolls over to avoid gaps
in the data.
Isco offers a 6700 sampler controller with an expanded memory
capacity. Instead of the standard 128 kilobytes, this controller has
4 megabytes of RAM available for program and data storage. Contact
the factory or your sales representative for more information.
FLASH MEMORY AND SOFTWARE UPGRADES
The sampler has Flash memory to store its software. With Flash
technology, you can upgrade your sampler’s software without
sending it back to the factory or replacing a chip. Simply connect
a computer to the sampler and run the Flash Update program.
102
INTERVAL CHANGED --
STORED DATA WILL
BE LOST! OK?
YES NO
PARTITION MEMORY
WILL LAST 13 DAYS