INSTRUCTION BOOK - Janome

More documents

Recommendations

Info

• Straight Stitch or Machine Setting Stitch Length 1.5 ~ 4 > A: Zigzag Foot While holding the threads with your left hand, turn the handwheel toward you to bring the needle into the fabric where you wish to start sewing. Lower the presser foot, and then start sewing slowly. SECTION III SEWING q w q Bring the needle down into the fabric, and raise the presser foot. w Then pivot the fabric to the desired direction. Lower the foot to start sewing. 15
16 qw e q For fastening the end of seams, press the reverse stitch lever and sew several reverse stitches. w Turn the handwheel so that the take-up lever is at its highest position. Raise the presser foot and draw the fabric out to the rear. e Cut the threads with the thread cutter, leaving the thread ends the proper length for starting the next seam. • Zigzag Stitch Machine Setting Stitch Length 0.3 ~ 4 A: Zigzag Foot Zigzag width can be adjusted within the range illustrated by the symbol.
Page 1 and 2: INSTRUCTION BOOK MODEL 712T
Page 3 and 4: • Names of Parts 2 1. 2. 3. 4. 5.
Page 5 and 6: • How to Install the Spool Pin
Page 7 and 8: • Changing Needles 6 Needle clamp
Page 9 and 10: • Removing the Bobbin • Setting
Page 11 and 12: • Inserting the Bobbin q w 10 q P
Page 13 and 14: • Drawing up Bobbin Thread • Ba
Page 15: • Dropping the Feed Dogs 14 To dr
Page 19 and 20: • Blind Hemming 18 or Wrong side
Page 21 and 22: u i 20 u Set the pattern selector d
Page 23 and 24: Attach the zipper foot with the pin
Page 25 and 26: • Rolled Hem 24 Machine Setting S
Page 27 and 28: t 26 r Brush off the lint on the fe
Page 29 and 30: • Troubleshooting 28 Condition Th
Page 31 and 32: 749-800-011 (E-N) Printed in Taiwan

INSTRUCTION BOOK - Janome

Create successful ePaper yourself

Delete template?

Save as template?