Integrating Draping, Drafting, & Drawing - Fairchild Books

More documents

Recommendations

Info

Drawing Darts for This Bodice 3 Draw seam and dart lines with a pencil, using straight and curve rulers. Mark length grain lines parallel to the center lines. 4 Cut straight lines with a blade. Use scissors or pattern shears to cut curved lines. Seam allowances are not necessary on slopers. 5 Notch the dart legs, armholes and cross grain line at side seam. 6 Punch a hole at the apex of the darts. 7 Complete the sloper by punching a large hole and hanging it on a pattern hook. Fit Construction Detail Flat of This Bodice BODICE |67 67
Integrating Draping, Drafting, and Drawing | 68 Drafting the Bodice from Measurements N L K+ + + I+ H D 1 Center front length (base of neck to waist) + M L1 G E + A 1” J + + + + B J1 F I+ + 1/2” 7/8” H D Back N Z3 L K+ + + V + X + + M L1 5/8” + P G E Front Q + + O C + A J + + + + B J1 U Y F T Back W + W1 approx. 1” + Z4 _ + + P armplate screw Z1 _ Z2+ S1 approx. 1” + S 11/4” R + Front Q + 1/4” + O C 2 Bust circumference (fullest part at bust level). Pin tape parallel to the floor N L K+ + + I+ H D V + 3/8” X + + M L1 3 Front neck to bust level G E 4 1 ⁄2 bust circumference CF to CB + A 1” 1” J + + 1” 1” + + B J1 U Y F T I+ + H D Back W + 3/4” W1 N Z3 L K+ + + + M L1 + P G E + S 1” S1 1” R + Front Q + + O C + A J + + + + + B J1 U Y F T 1” Accurate measurements are required to draft a bodice sloper. Carefully measure the dress form or human figure and record these illustrated measurements. The following pages provide step-by-step drafting instructions. Measuring the Dress Form V + X + Back W + W1 + Z4 _ + + P Z1 _ Z2+ S1 + S R + Front Q + + O C
Page 1 and 2: BF SEE INSIDE FOR SAMPLE MATERIAL F
Page 4 and 5: Integrating Draping, Drafting, and
Page 6 and 7: Integrating Draping, Drafting, and
Page 8 and 9: With experience gained from produci
Page 10 and 11: 1 2 Drape the Neckline 4 1 Pin at t
Page 12 and 13: Torn Edge Shoulder Blade Level Bust
Page 14 and 15: Join the Front and Back Bodice 1 Fo
Page 16 and 17: 6 Lower the armhole at side seam 1.
Page 18 and 19: 15 Pin the trued and trimmed muslin
Page 22 and 23: 5 Side seam (waist to 1 below arm p
Page 24 and 25: 22 C to R = 1 ⁄2 the Bust Point t
Page 26 and 27: Drafting the Waistline and Shoulder
Page 28 and 29: Shaping the Bodice Full Front Bust
Page 30: Shape Shape Darts Shape Darts Big O

Integrating Draping, Drafting, & Drawing - Fairchild Books

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?