AT+i Programmer's Manual - SE Spezial-Electronic AG

Nonvolatile Parameter Database
33.7.2 +iHDL — Limit Number of Header Lines
Syntax: AT+iHDL=n Sets maximum number of header lines to retrieve.
Parameters: n = 0 – 255
Default: 0 (no limit)
Result code:
I/OK If n is within limits
I/ERROR Otherwise
AT+iHDL~n Temporarily set the maximum limit of header lines
for the duration of the next session. The permanent
value will be restored after completing the next
session, whether the session was successful or not.
AT+iHDL? Report the current value of the header line limit.
The reply is followed by I/OK.
AT+iHDL=? Returns the message "0-255".
The reply is followed by I/OK.