AT+i Programmer's Manual - SE Spezial-Electronic AG

Nonvolatile Parameter Database
33.5.11 +NTOD — Define Network Time-of-Day Activation Flag
Syntax: AT+iNTOD=n Sets the network time-of-day activation flag to n.
Parameters: n=0 or 1
Command Options: n = 0: Network Time retrieval from timeserver is
disabled.
n = 1: Network Time retrieval is enabled – iChip
will connect to the Time Server and
retrieve an updated time reading each time
it connects to the network. From that point
on, iChip will maintain time internally.
While iChip is online, network time shall
be refreshed every two hours.
Current Time-of-Day will be returned in
response to the RP8 command. Outgoing
Email messages will be Time and Date
stamped.
The expiry data of an incoming server
certificate in secure SSL communication
will also be checked. If iChip cannot read
the time from the time server, an SSL
session cannot be established.
Default: 0 (timeserver retrieval disabled)
Result code:
I/OK
AT+iNTOD~n Temporarily set the Network Time-of-Day
activation flag to value n. The permanent value will
be restored after completing the next session,
whether the session was successful or not.
AT+iNTOD? Report the current value of the Network Time-of-
Day activation flag.
The reply is followed by I/OK.
AT+iNTOD=? Returns the message ‗0-1‘.
The reply is followed by I/OK.