AT+i Programmer's Manual - SE Spezial-Electronic AG

25.3 Header Parameter Names and Values
Name Value Default
RP_DEST Single NONE
RP_GROUP
string, no
space
characters
NONE
RP_START_FROM_FACTORY_DEFAULTS YES/NO NO
Table 25-1 Header Parameter Names and Values
iChip Parameter Update
RP_GROUP — If the RPF Group Name parameter contains a value, the RPF file
must include an RP_GROUP definition and its value must be identical to the RPF
value. Otherwise, the parameter update file will be rejected. Nevertheless, if the RPF
parameter is set to the special value (*) (match any), the RPF file will be accepted
with any value of RP_GROUP, as well as without any value at all. The RPF Group
Name parameter can be viewed and changed by sending an AT+iRPG? command to
iChip.
RP_DEST — If the RPF file contains this parameter, the parameter update file will
be rejected unless the value given in this parameter is identical to the unique ID of the
iChip it was sent to. The unique ID can be viewed by sending an AT+iRP5 command
to iChip, but cannot be changed. This feature facilitates sending a parameter update to
a specific iChip controller only.
RP_START_FROM_FACTORY_DEFAULTS — This flag defines the initial
value of parameters. A YES value will initially restore all iChip parameters to their
factory default values before processing the new RPF file values.