Wood Lathe With Stand

More documents

Recommendations

Info

CHANGINGSPINDLESPEEDS When changing speeds on your wood lathe, proceed as follows: 1. DISCONNECT THE MACHINE FROM THE POWER SOURCE. 2. Loosen screw (A) Fig. 17, and remove rear headstock guard (8). 3. Lift up rear end of motor and insert special tool (8) Fig. 18, into hole on rear of top shelf assembly with end of special tool holding motor plate in the up position. This releases tension on the belt. 4. Position belt on the desired steps of the spindle and motor pulleys and remove special tool (8) Fig. 18. 6. Replace rear headstock guard (8) Fig. 17. ASSEMBLINGHEADSTOCK ACCESSORIES The 46-083 Spur (Drive) Center and the 46-091 3" diameter Face Plate are supplied as standard equipment with your lathe. The Spur Center is shipped assembled to the headstock. To remove and install headstock accessories, proceed as follows: 1. Disconnect the machine from the power source. 2. Using special tool (A) Fig. 19, insert one end of special tool into hole in spindle as shown and remove drive center (8) using hex wrench (C). 3. Fig. 20, illustrates the 46-091 3" Diameter face plate assembled to the spindle. 8 Fig.17 1
TOOLRESTADJUSTMENTS To move the tool rest support along the lathe bed, loosen bolt (A) Fig, 21, and slide tool rest support (B) to the desired position on the bed. When in position, tighten bolt (A). For most normal lathe operations, the tool rest (C) Fig. 21, should be positioned about 1/8" away from the work and 1/8" above the work centerline. This position can be varied to suit the work and the operator. To adjust the height of the tool rest (C) loosen lock lever (0) and position tool rest to the desired height. Then tighten lock lever (0). TAILSTOCKADJUSTMENTS To move the ram (A) Fig. 22, in or out, loosen lock knob (B) and turn handwheel (C). When ram is in desired position, tighten lock knob (B). To slide the complete tailstock- along the lathe bed, loosen lock knob (0), slide tailstock to desired position and tighten lock knob (0). ASSEMBLINGACCESSORY 46-146 16" BEDSECTION Available as an accessory for your lathe is the 46-146 16" Bed Section which increases the distance between centers from 36 inches to 52 inches for turning extra long stock. To assemble the accessory 46-146 16" Bed Section to your lathe, proceed as follows: 1. Removethe lathe from the stand. 2. Remove bolt (A), nut (8) and washer (C) Fig. 23, that fasten the two sections of the lathe bed together. 3. Pry apart the two sections of the lathe bed. The two dowel pins (0) Fig. 24, should remain in headstock end of lathe bed, as shown. 9 Fig.22 Fig.23 Fig. 24 .
Page 1 and 2: c . I;,on nua,1 I I i J j f I i 1 I
Page 3 and 4: ADDITIONALSAFETYRULESFORWOODLATHES
Page 5 and 6: .. ASSEMBLINGMOTORPULLEY TO MOTORSH
Page 7: . GROUNDINGINSTRUCTIONS CONNECTINGL
Page 11 and 12: WOOD-TURNING SPEEDS Di ameter Of Wo
Page 13 and 14: OPERATION The following directions
Page 15 and 16: ROUGHING A CYLINDER. The large goug
Page 17 and 18: . .. CUTTING A SHOULDER. The partin
Page 19 and 20: The gouge is placed on edge on the

Wood Lathe With Stand

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?