You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
..<br />
ASSEMBLINGMOTORPULLEY<br />
TO MOTORSHAFT<br />
Assemble motor pulley (A) to motor shaft with smallest<br />
groove of motor pulley toward the motor, as shown in Fig. 6.<br />
Tighten set screw (8) against key in motor shaft.<br />
ASSEMBLINGMOTORTO<br />
HINGEBRACKET<br />
Place motor base on hinge bracket and fasten using the two<br />
5/16 - 18 x 1" long carriage bolts (A), 1/8" flat washer (B),<br />
5/16" external tooth lockwasher (C) and two 5/16 - 18 hex<br />
nuts (D), as shown in Fig. 7. IMPORTANT. The proper<br />
grounding of the motor to prevent shock hazard, depends on<br />
the use of the external tooth lockwasher (C) as shown.<br />
ASSEMBLIN GROUNDWIRETO<br />
MOTORANDSTAND<br />
1. Place 5/16" external tooth lockwasher (A) and ground<br />
wire (8) on carriage bolt, as shown in Fig. 8.<br />
2. Fasten ground wire (8) to carriage bolt using the 5/16 -<br />
18 hex nut (C) as shown in Fig. 9.<br />
3. Fasten remaining end of ground wire (8) to stand using<br />
the 1/2" long round head screw (D). external tooth lockwasher<br />
(E) and hex nut (F), as shown in Fig. 10. IMPOR-<br />
TANT: The proper grounding of the motor to prevent shock<br />
hazard, depends on the use of the external tooth lockwashers<br />
(A) Fig. 8 and (E) Fig. 10, as shown.<br />
4. Replace stand to the uPJight position.<br />
5<br />
.
Change language