You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
MOTORSFORYOURLATHE<br />
The motors available fQr your lathe are:<br />
ASSEMBLINGMOTORMOUNTING<br />
HINGEBRACKET .<br />
Assemble the motor mounting hinge bracket as shown in<br />
Fig. 3, using the two 5/16 - 18 x 5/8" long hex cap screws<br />
and 5/16 -18 hex lock nuts.<br />
ASSEMBLINGHINGEBRACKETO<br />
STAND<br />
1. Turn stand upside down with top shelf of stand on<br />
floor, as shown in Fig. 4.<br />
2. Insert two 5/16 - 18 x 1" long carriage bolts up through<br />
the two holes (A) Fig. 4.<br />
3. Fasten motor mounting hinge bracket (B) Fig. 5, to the<br />
two carriage bolts that were inserted in STEP 2, using two<br />
1/8" washers and 5/16" -18 hex nuts (C), as shown.<br />
62-142, 1/2 H.P., ball bearing,. capacitor start, 1725<br />
RPM, 115 Volt with remote control toggle switch and<br />
cord.<br />
62-138, 1/2 H.P., sleeve bearing, split pha.se,1725 RPM,<br />
115 Volt with remote control toggle switch and cord.<br />
These motors have been specially selected to best supply<br />
power to your machine and the relative safety of the machine<br />
is enhanced by their use. We therefor~ strongly suggest that<br />
only these motors be used as the use of other motors may be<br />
detrimental to the performance and safety of your lathe.<br />
4<br />
'Fig. 3<br />
Fig.4<br />
I
Change language