You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ADDITIONALSAFETYRULESFORWOODLATHES<br />
1. MAKE SURE the tool rest height is adjusted properly.<br />
2. KEEPtool rest as close to the work as possible.<br />
3. REMOVE the tool rest before sanding or polishing.<br />
4. EXAMINEset-up carefully before turning on the power.<br />
5. ROTATE workpiece by hand to check clearance before<br />
engagingpower.<br />
6. WHEN TURNING between centers MAKE SURE the<br />
tailstock center is snug against the workpiece and locked.<br />
Tailstock center should be lubricated if it is not a ball bearing<br />
center.<br />
7. MAKE SURE screw fasteners do not interfere with the<br />
turning tool at the finished dimension of the workpiece when<br />
faceplate turning.<br />
5/16"-18 HEX NUT (16)<br />
~<br />
11/32" WASHER (16)<br />
5/16-18 x 3/4"<br />
\~.<br />
~.<br />
CARRIAGE BOLT (16)<br />
~.d<br />
5/16"-18 HEX NUT (16)<br />
11/32" WASHER (16)<br />
5/16-18 x 3/4"<br />
CARRIAGE BOLT (161 ~1.<br />
UNPACKINGANDCLEANING<br />
TOP SHELF~<br />
I<br />
u<br />
~<br />
The lathe, stand and all hardware necessary for assembly are<br />
shipped in one carton. Carefully unpack and separate all items.<br />
Remove the protective coating from the machined.surfaces of<br />
the lathe. This coating may be removed with a soft cloth<br />
moistened with kerosene (do not use acetone, gasoline or<br />
lacquer thinner for this purpose).<br />
8. EXAMINEworkpiece for flaws and test glue joints<br />
before placing workpiece in lathe.<br />
9. WHENroughing off, DO NOT jam tool into workpiece<br />
or take too big a cut.<br />
. 10. CHECK AND SELECT proper speed before turning<br />
lathe on.<br />
11. NEVER drive wood into drive center when it is in headstock.<br />
Set drive center into wood with a soft mallet prior to<br />
installing it in the lathe.<br />
12. NEVER loosen tailstock spindle while work is turning.<br />
13. NEVER adjust tool rest while work is turning.<br />
14. WHEN faceplate turning, be sure material is securely<br />
fastened to the faceplate.<br />
5/16-18 x 1"<br />
,, CARRIAGE BOLT (6)<br />
. ../<br />
.~<br />
WASHER<br />
I 5/16"-18<br />
IUT / (6) ~. \',<br />
.: .~/ ~.~. \/'GI.,<br />
47-112"<br />
/ ~<br />
"M<br />
BRACKET (2) ~ ~ ~<br />
~.<br />
53-5/8" BRACKET (2)<br />
3<br />
Fig. 2<br />
. '/ 1 FOOT(4)-----<br />
ASSEMBLINGSTAND<br />
Assemble the top shelf, support brackets, legs and side panel<br />
of the stand, as shown in Fig. 2. The correct size and quantity<br />
of the hardware necessaryto assemblethe stand is shown in<br />
Fig. 2. Place the fo,!r rubber feet on bottom of the four legs,<br />
asshown.<br />
.
Change language