You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4. Assemble 16" center section (F) to headstock end of<br />
lathe bed as shown in Fig. 25, making sure the two dowel<br />
pins are inserted into the two holes in the center section.<br />
Reinstall bolt, nut and washer (E) that were removed in STEP<br />
2. Do not completely tighten bolt and nut (E) at this time.<br />
5. Using the special gage (G) Fig. 26, supplied with acces-<br />
so", center section, place it between the headstock end of the<br />
lathe bed and the center section as shown in Fig. 27 to assure<br />
beds line up and tighten nut and bolt that hold both sections<br />
together.<br />
6. <strong>With</strong> the two extra dowel pins, and the extra bolt,<br />
washer and nut supplied with accessory bed section, assemble<br />
tailstock end of lathe bed to the center section in the same<br />
manner.<br />
7. Fig. 28, illustrates the lathe with the 46-146 center<br />
section assembled. If you desire to use the lathe with the<br />
standard stand, we suggestconstructing a new top shelf for<br />
the stand adding 16 to 20 inches to the tailstock end of the<br />
shelf.<br />
Fig. 28<br />
10<br />
Fig. 25<br />
Fig. 27<br />
1
Change language