External Dental Implant Catalog - BioHorizons
External Dental Implant Catalog - BioHorizons
External Dental Implant Catalog - BioHorizons
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
The Surgical Drills included in the <strong>External</strong> Surgical Kit are externally irrigated and designed to be used at speeds of 850-2,500<br />
rpm 9 with steady sterile irrigation. Reduced drill speed may be desired in softer bone or as drill diameter increases.<br />
The depth marks are consistent throughout the Starter Drill, Depth Drills and Width Increasing Drills. The thick bands are<br />
each one millimeter wide. Thin lines are used to mark 7mm and 11mm.<br />
Peri-operative oral rinses with a 0.12% Chlorhexidine Digluconate solution have been shown to significantly lower the<br />
incidence of post-implantation infectious complications. 10 A preoperative 30-second rinse is recommended, followed by<br />
twice daily rinses for two weeks following surgery.<br />
Drilling must be done under a constant stream of sterile irrigation. A pumping motion should be employed to prevent overheating<br />
the bone. Surgical drills and taps should be replaced when they are worn, dull, corroded or in any way compromised.<br />
<strong>BioHorizons</strong> recommends the replacement of drills after 12 to 20 osteotomies. 11 A Drill-usage Tracking Chart is available from<br />
<strong>BioHorizons</strong> to aid offices in archiving this important information.<br />
There is a risk of injury to the mandibular nerve associated with surgical drilling in lower posterior regions. To minimize the<br />
risk of nerve injury, it is imperative the clinician understand the drill depth markings in order to correlate implant length with<br />
the actual drilling depth to produce the desired vertical placement of the implant.<br />
products products shown shown not to scale scale<br />
14mm<br />
12mm<br />
10mm<br />
Drilling Considerations<br />
30<br />
SURGICAL DRILLS<br />
15mm<br />
13mm<br />
11mm<br />
9mm<br />
7mm