3 phase electric powered single compartment sump sucker - Master ...

PROBLEM PART TO CHECK POSSIBLE SOLUTION
Engine stalls during discharge 1. Engine 1. Check engine RPM; adjust as necessary
or suction
2. Regulator 2. Pressure or vacuum regulator could be out of
adjustment; contact a Service Technician at
The Andersons, Systems Equipment Division
3. Pneumatic Muffler 3. Ensure pneumatic muffler is not covered with
dirt/oils; clean or replace
4. LP system 5. Check if LP system is frozen or not
working correctly, repair or replace
Excessive Noise 1. Blower 1. Blower rotors are out of time and knock; replace
2. Blower muffler 2A. Check muffler for rust out or holes; replace
2B. Check mufflers for liquid saturation; drain and dry
or replace
3. Pneumatic muffler 3. Check to see if pneumatic muffler is rusted out,
replace
4. Engine Muffler 4. Check to see if engine muffler is rusted out;
replace
5. RPM’s too high 5. Check engine RPM for proper speed;
adjust engine
6. Air Venturi silencer 6. Check for liquid saturation; drain and dry or
replace
Portability 1. Hard to push 1A. Check for worn wheels or casters; replace
1B. Check wheel and caster bearings: grease or
replace
1C. Rough Floors: investigate a tow unit or use a
forklift to transport
ALWAYS CHECK YOUR MANUAL FOR OPERATION INSTRUCTIONS AND MAINTENANCE
This unit Supplied by
Page 22 of 22