3 phase electric powered single compartment sump sucker - Master ...

4. As soon as fluid stops passing through the hose, press the STOP button to turn off the
motor. A. The compartment’s maximum capacity is, at most, 10% above the rated
capacity. The float switch described in Paragraphs 3 and 4 above, and located near the
compartment suction fitting, will shut off the motor if overfilling starts to occur. If this
should happen, follow instructions for the discharge operation in Paragraph 7 below.
5. To return filtered chip-free coolant to the sump, or wash down the machine, or
discharge dirty coolant into your recycling or disposal system, close the suction inlet
ball valve. Push the DISCHARGE button and depress the discharge hose nozzle valve.
A. Be sure the suction inlet ball valve is fully closed before operating in the
DISCHARGE mode!
B. IMPORTANT! Be sure the suction inlet ball valve is fully closed or fully open,
depending on the desired operation (closed-discharge, open-suction). Failure to
do so will allow particulates to enter the valve seat and seize the valve.
6. Stop the motor as soon as fluid stops passing through the hose.
A. The cleaner is to be adjusted and/or repaired only by qualified service
personnel. If these personnel need more information than is provided in this
manual, they should contact The Andersons at 419-891-2724
B. The sump cleaner will discharge all but about an inch of fluid in the bottom of
the compartment. This is unimportant if the compartment cleaner is used for one
type of coolant only. If different coolants are to be handled in that compartment,
remove its drain plug to empty it completely.
7. To empty the filter basket:
A. Remove tower lid.
B. Attach lifting device to basket rings. CAUTION: All components used to lift
basket (steel cable, hooks, crane, etc.) must have a minimum capacity of 1000
pounds.
C. To avoid the basket binding in the tower during removal, position the lifting
power source (e.g. crane) directly over the center of the basket.
Page 11 of 22