NS7 Reference Manual - v1.1 - Numark

TOP PANEL OVERVIEW
32 33
34
18
36
37
38
39
31
35
17
19
27 28
26
16
MIXER CONTROLS
21
15
29 30
22 23 24 25
14
13
20 20 20 20 20
1
2
3
4
5
41
42 42
43 44 45
46
40
47
7
8
9
10
11
12
6
6
46
1
2
3
4
5
27 28
26
13
19 20 20 20 20 20
16
21
22 23 24 25
1. GAIN TRIM – Adjusts the pre-fader, pre-EQ audio level of the corresponding channel in the software.
2. CHANNEL TREBLE – Adjusts the high (treble) frequencies.
3. CHANNEL MID – Adjusts the mid-range frequencies.
4. CHANNEL BASS – Adjusts the low (bass) frequencies.
5. CHANNEL FADER – Adjusts the audio level on the corresponding channel in the software.
6. CROSSFADER – Blends audio between the channels assigned to the left and right side of the crossfader.
Note: The crossfader is user-replaceable if it should ever wear out. Simply remove the facepanel, then remove the screws holding
it in position. Replace the fader with a quality authorized replacement from your local Numark retailer only.
7. MASTER VOLUME – Adjusts the output volume of the Program Mix.
8. BOOTH VOLUME – Adjusts the output volume of the BOOTH OUTPUT mix.
9. HEADPHONE MIX – Blends the pre-fader audio playing on Channels 1 and 2. Sliding this to the left plays Channel 1. Sliding to
the right plays Channel 2.
10. HEADPHONE MODE – Selects the audio that is sent to the headphones. Switch it to “MASTER” to hear the Program Mix. Switch
it to “CH1 CH2” to hear a mix of Channels 1 and 2 in the headphones.
11. METER MODE – Determines whether audio from the Program Mix or the Cue Channel is sent to the LED METERS. When set to
“CH1-CH2,” the Cue Channel will be monitored (Channel 1 in the left meter, Channel 2 in the right meter). When set to “MASTER,”
the Program Mix will be monitored in stereo.
12. LED METERS – Monitors the audio levels of the Program Mix or Cue Channel, depending on the position of the METER MODE
switch.
15
29 30
14
31
35
17
32 33
34
18
36
37
38
39