Legacy® PLUS - Smiths Medical

More documents

Recommendations

Info

Reference Section 5: Reference Pump Alarms .....................Low battery power; depleted battery power; battery dislodged; pump stopped; pump fault; low reservoir volume; high delivery pressure; air in line; disposable not attached when run attempted; motor locked; upstream occlusion; reservoir volume empty; program incomplete; key stuck; disposable detached. Maximum Infusion Pressure ..............................40.0 psi [2.76 bar] Maximum Time to Occlusion Alarm ...............0.1 ml/hr: 2.0 hours 24 ml/hr: 78 seconds Bolus Volume at Occlusion Alarm Pressure ...............................0.1 ml/hr:
Section 5: Reference System Delivery Accuracy .............................± 6% (nominal). At low infusion rates, this accuracy may not be achieved for short periods. During the total infusion time, the accuracy averages out (see accuracy curves, pages 62 and 63) WARNING: Ensure that the ± 6% System Delivery Accuracy specification is taken into account when programming the pump and/or filling the Medication Cassette Reservoir. Failure to do so may result in medication in the reservoir becoming depleted sooner than expected. If the pump is being used to deliver critical or life sustaining medication, the interruption in the delivery of medication could result in patient injury or death. System Definition ..............System is defined as a CADD-<strong>Legacy®</strong> pump with an attached Medication Cassette Reservoir and CADD Extension Set with integral antisiphon valve, or an attached CADD Administration Set with integral or add-on anti-siphon valve. OR a CADD-<strong>Legacy®</strong> pump with an attached Medication Cassette Reservoir with flow stop feature and CADD Extension Set, or a CADD Administration Set with flow stop feature (catalog numbers start with 21-73xx). High Pressure Alarm ........26 ± 14 psi [1.79 ± 0.97 bar]. Air Detector Alarm ...........Single bubble Low sensitivity = greater than 0.250 ml High Sensitivity = greater than 0.100 ml Multi-bubble = 1.0 ml nominal Maximum Volume Infused under Single Fault Condition .................CADD Administration Set: 0.2 ml. Delivery Rate during priming ...............................Approx. 180 ml/hr Alarm Disabled during priming ...............................Air Detector Reference
Page 1 and 2:
Legacy Operator’s Manual CADD-Leg
Page 3 and 4:
Read this entire Operator’s Manua
Page 5 and 6:
• Do not use rechargeable NiCad o
Page 7 and 8:
• Do not expose the pump to humid
Page 9 and 10:
Table of Contents Warnings iii Caut
Page 11 and 12:
1.0 General Description Section 1:
Page 13 and 14:
Symbols O Direct Current (Power Jac
Page 15 and 16:
Section 1: General Description Desc
Page 17 and 18: Section 1: General Description WARN
Page 19 and 20: Lock Levels Section 1: General Desc
Page 21 and 22: 2.0 Pump Setup and Programming Inst
Page 23 and 24: Section 2: Pump Setup and Programmi
Page 27 and 28: Changing to Lock Level 0 (LL0) Sect
Page 29 and 30: Delivery Methods Section 2: Pump Se
Page 33 and 34: Programming Continuous Delivery Sec
Page 37 and 38: KVO Rate Section 2: Pump Setup and
Page 39 and 40: Programming Intermittent Delivery S
Page 41 and 42: • Press „. 11. Verify the Upstr
Page 43 and 44: Attaching a Cassette Section 2: Pum
Page 49 and 50: Setting the Lock Level for the Pati
Page 53 and 54: 3.0 Operating the Pump Starting the
Page 55 and 56: 4.0 Biomed Functions Overview: Acce
Page 57 and 58: Upstream Sensor On/Off Section 4: B
Page 59 and 60: 5.0 Reference Messages and Alarms,
Page 61 and 62: Section 5: Reference Messages and A
Page 63 and 64: Cleaning the Pump and Accessories S
Page 65 and 66: Section 5: Reference Exposure to Ra
Page 67: Section 5: Reference IEC 61000-4-4
Page 71 and 72: Biomed Functions Air Detector .....
Page 73 and 74: Flow rate: Minimum Time Interval: 1
Page 75 and 76: Section 5: Reference WARNING: The P
Page 77 and 78: Recommended separation distances be
Page 79 and 80: Section 5: Reference the motor driv
Page 81 and 82: Data Handling Software Safety Featu
Page 83 and 84: Mechanical Inspection Section 5: Re
Page 85 and 86: Section 5: Reference • Press and
Page 87 and 88: Upstream Occlusion Sensor Test Sect
Page 89 and 90: Occlusion Pressure Range Test II De
Page 91 and 92: Accuracy Tests Gravimetric Accuracy
Page 93 and 94: Example: Predelivery Weight: 61.1 g
Page 95 and 96: Section 5: Reference 5. Program a C
Page 97 and 98: indicator light, 4 inspection proce
Page 99 and 100: E. Computer Program License: Sectio
show all

Legacy® PLUS - Smiths Medical

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?