Legacy® PLUS - Smiths Medical

More documents

Recommendations

Info

Pump Setup & Programming Section 2: Pump Setup and Programming Programming the Pump: General Instructions The procedure for changing a programmed setting is similar for most programming screens. WARNING: Ensure that the ± 6% System Delivery Accuracy specification is taken into account when programming the pump and/or filling the Medication Cassette Reservoir. Failure to do so may result in medication in the reservoir becoming depleted sooner than expected. If the pump is being used to deliver critical or life sustaining medication, the interruption in the delivery of medication could result in patient injury or death. • Make sure the pump is stopped and in Lock Level 0. • To begin programming, start at the main screen and press „. • To change a setting, press ´ or Î until the desired setting appears. (Press and hold these keys to change values with increasing speed.) • Press ¤ within 25 seconds to confirm a change or the screen will revert to the previous setting. • If any key other than ¤ is pressed, “Value not saved” will appear. Press „ to return to the screen being programmed, scroll to the desired value, and press ¤. • Press „ to advance to the next screen. • To leave a setting unchanged, press „ to go to the next screen.
Delivery Methods Section 2: Pump Setup and Programming WARNING: This pump delivers medication at a continuous rate or intermittent rate in milliliters per hour (ml/hr). Programming the pump at a delivery rate other than what is prescribed will cause over or under delivery of medication, which could result in patient injury or death. The CADD-<strong>Legacy®</strong> <strong>PLUS</strong> pump has 2 delivery methods, and provides delivery in milliliters per hour: • Continuous Delivery Mode (up to 125 ml per hour) • Intermittent Delivery Mode (up to 125 ml per hour) The Continuous Delivery Mode (CDM) permits a steady infusion rate. In this mode, you can program the pump to deliver medication at a constant rate in milliliters per hour. Del very Rate (ml/hr) T me Pump Setup & Programming
Page 1 and 2: Legacy Operator’s Manual CADD-Leg
Page 3 and 4: Read this entire Operator’s Manua
Page 5 and 6: • Do not use rechargeable NiCad o
Page 7 and 8: • Do not expose the pump to humid
Page 9 and 10: Table of Contents Warnings iii Caut
Page 11 and 12: 1.0 General Description Section 1:
Page 13 and 14: Symbols O Direct Current (Power Jac
Page 15 and 16: Section 1: General Description Desc
Page 17 and 18: Section 1: General Description WARN
Page 19 and 20: Lock Levels Section 1: General Desc
Page 21 and 22: 2.0 Pump Setup and Programming Inst
Page 23 and 24: Section 2: Pump Setup and Programmi
Page 27: Changing to Lock Level 0 (LL0) Sect
Page 33 and 34: Programming Continuous Delivery Sec
Page 37 and 38: KVO Rate Section 2: Pump Setup and
Page 39 and 40: Programming Intermittent Delivery S
Page 41 and 42: • Press „. 11. Verify the Upstr
Page 43 and 44: Attaching a Cassette Section 2: Pum
Page 49 and 50: Setting the Lock Level for the Pati
Page 53 and 54: 3.0 Operating the Pump Starting the
Page 55 and 56: 4.0 Biomed Functions Overview: Acce
Page 57 and 58: Upstream Sensor On/Off Section 4: B
Page 59 and 60: 5.0 Reference Messages and Alarms,
Page 61 and 62: Section 5: Reference Messages and A
Page 63 and 64: Cleaning the Pump and Accessories S
Page 65 and 66: Section 5: Reference Exposure to Ra
Page 67 and 68: Section 5: Reference IEC 61000-4-4
Page 69 and 70: Section 5: Reference System Deliver
Page 71 and 72: Biomed Functions Air Detector .....
Page 73 and 74: Flow rate: Minimum Time Interval: 1
Page 75 and 76: Section 5: Reference WARNING: The P
Page 77 and 78: Recommended separation distances be
Page 79 and 80:
Section 5: Reference the motor driv
Page 81 and 82:
Data Handling Software Safety Featu
Page 83 and 84:
Mechanical Inspection Section 5: Re
Page 85 and 86:
Section 5: Reference • Press and
Page 87 and 88:
Upstream Occlusion Sensor Test Sect
Page 89 and 90:
Occlusion Pressure Range Test II De
Page 91 and 92:
Accuracy Tests Gravimetric Accuracy
Page 93 and 94:
Example: Predelivery Weight: 61.1 g
Page 95 and 96:
Section 5: Reference 5. Program a C
Page 97 and 98:
indicator light, 4 inspection proce
Page 99 and 100:
E. Computer Program License: Sectio
show all

Legacy® PLUS - Smiths Medical

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?