Legacy® PLUS - Smiths Medical

More documents

Recommendations

Info

General Description Section 1: General Description Lock Level Table This table lists the operations that are accessible in each lock level while the pump is stopped and running. LL0 permits complete access to all programming and operating functions. LL1 permits limited control of pump programming and operations. LL2 permits only minimal control of pump operations. *Continuous Delivery Mode = CDM; Intermittent Delivery Mode = IDM Pump Operations and Programming 0 Stopped Running LL0 LL1 LL2 Any Lock Level Stop/Start the pump Yes Yes Yes Yes Reset Reservo r Volume Yes Yes Yes No Pr me Yes Yes No No Change the Lock Level Change Cont nuous Rate (CDM)* Clear G ven amount (CDM & IDM)* Yes, w/ code Yes Yes, w/ code Up to LL0 value Yes, w/ code No No No Yes Yes No No Change Dose Volume (IDM)* Yes No No No Change Dose Durat on (IDM)* Yes No No No Change Dose Cycle (IDM)* Yes No No No Change KVO Rate (IDM)* Yes No No No Change Dose Starts n Delay (IDM)* Biomed Functions Access to Funct ons A r Detector On/Off Upstream Occlus on Sensor On/Off Chang ng the Del very Mode Yes Yes No No Yes, w/ code No No No Yes, w/ code Yes, w/ code Yes, w/ code V ew Only V ew Only V ew Only V ew Only V ew Only V ew Only V ew Only V ew Only V ew Only
2.0 Pump Setup and Programming Installing or Replacing the Batteries Section 2: Pump Setup and Programming Use new, AA (IEC LR6) alkaline batteries such as DURACELL® or EVEREADY® ENERGIZER® batteries. The pump retains all programmed values while the batteries are removed. Some of the programmed values are retained in RAM memory that is supported by an internal battery for 5 years from date of manufacture. Dispose of used batteries in an environmentally safe manner, and according to any regulations which may apply. WARNING: • Do not use rechargeable NiCad or nickel metal hydride (NiMH) batteries. Do not use carbon zinc (“heavy duty”) batteries. They do not provide sufficient power for the pump to operate properly, which could result in death or serious injury to the patient. • Always have new batteries available for replacement. If power is lost, non-delivery of medication will occur, and depending on the type of medication being administered, could result in death or serious injury to the patient. • If the pump is dropped or hit, the battery door or tabs may break. Do not use the pump if the battery door or tabs are damaged because the batteries will not be properly secured; this may result in loss of power, non-delivery of medication, and depending on the type of medication being administered, death or serious injury to the patient. Pump Setup & Programming
Page 1 and 2: Legacy Operator’s Manual CADD-Leg
Page 3 and 4: Read this entire Operator’s Manua
Page 5 and 6: • Do not use rechargeable NiCad o
Page 7 and 8: • Do not expose the pump to humid
Page 9 and 10: Table of Contents Warnings iii Caut
Page 11 and 12: 1.0 General Description Section 1:
Page 13 and 14: Symbols O Direct Current (Power Jac
Page 15 and 16: Section 1: General Description Desc
Page 17 and 18: Section 1: General Description WARN
Page 19: Lock Levels Section 1: General Desc
Page 23 and 24: Section 2: Pump Setup and Programmi
Page 27 and 28: Changing to Lock Level 0 (LL0) Sect
Page 29 and 30: Delivery Methods Section 2: Pump Se
Page 33 and 34: Programming Continuous Delivery Sec
Page 37 and 38: KVO Rate Section 2: Pump Setup and
Page 39 and 40: Programming Intermittent Delivery S
Page 41 and 42: • Press „. 11. Verify the Upstr
Page 43 and 44: Attaching a Cassette Section 2: Pum
Page 49 and 50: Setting the Lock Level for the Pati
Page 53 and 54: 3.0 Operating the Pump Starting the
Page 55 and 56: 4.0 Biomed Functions Overview: Acce
Page 57 and 58: Upstream Sensor On/Off Section 4: B
Page 59 and 60: 5.0 Reference Messages and Alarms,
Page 61 and 62: Section 5: Reference Messages and A
Page 63 and 64: Cleaning the Pump and Accessories S
Page 65 and 66: Section 5: Reference Exposure to Ra
Page 67 and 68: Section 5: Reference IEC 61000-4-4
Page 69 and 70: Section 5: Reference System Deliver
Page 71 and 72:
Biomed Functions Air Detector .....
Page 73 and 74:
Flow rate: Minimum Time Interval: 1
Page 75 and 76:
Section 5: Reference WARNING: The P
Page 77 and 78:
Recommended separation distances be
Page 79 and 80:
Section 5: Reference the motor driv
Page 81 and 82:
Data Handling Software Safety Featu
Page 83 and 84:
Mechanical Inspection Section 5: Re
Page 85 and 86:
Section 5: Reference • Press and
Page 87 and 88:
Upstream Occlusion Sensor Test Sect
Page 89 and 90:
Occlusion Pressure Range Test II De
Page 91 and 92:
Accuracy Tests Gravimetric Accuracy
Page 93 and 94:
Example: Predelivery Weight: 61.1 g
Page 95 and 96:
Section 5: Reference 5. Program a C
Page 97 and 98:
indicator light, 4 inspection proce
Page 99 and 100:
E. Computer Program License: Sectio
show all

Legacy® PLUS - Smiths Medical

Create successful ePaper yourself

Delete template?

Save as template?