Legacy® PLUS - Smiths Medical

More documents

Recommendations

Info

This manual pertains only to the CADD-Legacy® PLUS Model 6500 ambulatory infusion pump. There are other CADD-Legacy® pump models available; review the rear label of the pump to ensure it is a CADD-Legacy® PLUS Model 6500 pump before programming. This pump delivers medication at a continuous rate or intermittent rate in milliliters per hour (ml/hr). This manual is intended for clinician use only. Do not permit patients to have access to this manual. The pump has 3 security levels designed to limit patient access. Do not disclose the pump’s security codes or any other information that would allow inappropriate access to programming and operating functions. The issue date of this Operator’s Manual is included on the back cover for the clinician’s information. In the event one year has elapsed between the issue date and product use, the clinician should contact Smiths Medical MD, Inc. to see if a later revision of this manual is available. Technical Assistance If you have comments or questions concerning the operation of the CADD-Legacy® pump, please call the appropriate number given below. When calling, please specify your pump’s software module. This information is located on the start-up screen. Our staff at Smiths Medical MD, Inc. is available to help clinicians 24 hours a day with the programming and operation of the CADD- Legacy® infusion system. U.S. Distribution European Representative Smiths Medical MD, Inc. Smiths Medical International Ltd. 1265 Grey Fox Road WD24 4LG UK St. Paul, MN 55112 USA +44 (0)1923 246434 1 800.426.2448 (USA) +1 651.633.2556
Read this entire Operator’s Manual before operating the CADD-Legacy® ambulatory infusion pump. Failure to properly follow warnings, cautions, and instructions could result in death or serious injury to the patient. Warnings • This Operator’s Manual should be used by clinicians only. Do not permit patients to have access to this manual, as the information contained would allow the patient complete access to all programming and operating functions. Improper programming could result in death or serious injury to the patient. • To avoid explosion hazard, do not use the pump in the presence of flammable anesthetics or explosive gases. • For those patients who are likely to be adversely affected by unintended operations and failures, including interrupted medication or fluid delivery from the device, close supervision and provision for immediate corrective action should be provided. • If the pump is used to deliver life-sustaining medication, a backup pump should be available. • The pump should not to be used for delivery of blood or cellular blood products. • If the pump is dropped or hit, inspect the pump for damage. Do not use a pump that is damaged or is not functioning properly. Contact Smiths Medical MD, Inc. Customer Service to return a pump for service. • Use of a syringe with the CADD Administration Set may result in UNDER-DELIVERY of medication. Syringe function can be adversely affected by variations in plunger dimension and lubricity, which can result in greater force required to move the syringe plunger. A syringe plunger will lose lubrication as it ages and, as a result, the amount of under-delivery will increase which could on occasion, be significant. Therefore, the type of medication and delivery accuracy required must be considered when using a syringe with the CADD® pump.
Page 1: Legacy Operator’s Manual CADD-Leg
Page 5 and 6: • Do not use rechargeable NiCad o
Page 7 and 8: • Do not expose the pump to humid
Page 9 and 10: Table of Contents Warnings iii Caut
Page 11 and 12: 1.0 General Description Section 1:
Page 13 and 14: Symbols O Direct Current (Power Jac
Page 15 and 16: Section 1: General Description Desc
Page 17 and 18: Section 1: General Description WARN
Page 19 and 20: Lock Levels Section 1: General Desc
Page 21 and 22: 2.0 Pump Setup and Programming Inst
Page 23 and 24: Section 2: Pump Setup and Programmi
Page 27 and 28: Changing to Lock Level 0 (LL0) Sect
Page 29 and 30: Delivery Methods Section 2: Pump Se
Page 33 and 34: Programming Continuous Delivery Sec
Page 37 and 38: KVO Rate Section 2: Pump Setup and
Page 39 and 40: Programming Intermittent Delivery S
Page 41 and 42: • Press „. 11. Verify the Upstr
Page 43 and 44: Attaching a Cassette Section 2: Pum
Page 49 and 50: Setting the Lock Level for the Pati
Page 53 and 54:
3.0 Operating the Pump Starting the
Page 55 and 56:
4.0 Biomed Functions Overview: Acce
Page 57 and 58:
Upstream Sensor On/Off Section 4: B
Page 59 and 60:
5.0 Reference Messages and Alarms,
Page 61 and 62:
Section 5: Reference Messages and A
Page 63 and 64:
Cleaning the Pump and Accessories S
Page 65 and 66:
Section 5: Reference Exposure to Ra
Page 67 and 68:
Section 5: Reference IEC 61000-4-4
Page 69 and 70:
Section 5: Reference System Deliver
Page 71 and 72:
Biomed Functions Air Detector .....
Page 73 and 74:
Flow rate: Minimum Time Interval: 1
Page 75 and 76:
Section 5: Reference WARNING: The P
Page 77 and 78:
Recommended separation distances be
Page 79 and 80:
Section 5: Reference the motor driv
Page 81 and 82:
Data Handling Software Safety Featu
Page 83 and 84:
Mechanical Inspection Section 5: Re
Page 85 and 86:
Section 5: Reference • Press and
Page 87 and 88:
Upstream Occlusion Sensor Test Sect
Page 89 and 90:
Occlusion Pressure Range Test II De
Page 91 and 92:
Accuracy Tests Gravimetric Accuracy
Page 93 and 94:
Example: Predelivery Weight: 61.1 g
Page 95 and 96:
Section 5: Reference 5. Program a C
Page 97 and 98:
indicator light, 4 inspection proce
Page 99 and 100:
E. Computer Program License: Sectio
show all

Legacy® PLUS - Smiths Medical

Create successful ePaper yourself

Delete template?

Save as template?